• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

MA MEP-1030, MEP-1040 Remote Start System with Wi-Fi & 2-Wire Start/Stop

kloppk

Well-known member
Steel Soldiers Supporter
2,145
3,526
113
Location
Pepperell, Massachusetts
Remote Start Controller Kits For use in MEP-1030 & MEP-1040 Generators
Wi-Fi Remote Control & 2-Wire Start/Stop with live Parameter Reporting and Data Logging

Features include:
· Remote genset Start/Stop over Wi-Fi via cell phone, laptop, tablet
· Direct Wi-Fi communication. No router needed. Works during power failures.
(Version also available with home Wi-Fi network integration)
· 300 foot plus WiFi range. Password protected
· Browser display of all engine and generator operating parameters on remote Wi-Fi device. Parameters nearing extremes are highlighted in red text.
· Ambient Temperature
· Battery Voltage
· AC Voltage on each output leg
· AC Output Frequency reading to 0.1 Hz
· Load Current on each leg
· Output Power (kW)
· Fuel Level
· Coolant Temperature
· Oil Pressure
· Remotely Enable and Disable the Auxiliary Fuel Pump system
· Remote control of the Contactor with the Contactor state displayed
· User calibration of all parameters
· Data Logging of all parameters as well as engine hours and Start/Stop count. Min, Average & Max values logged every 10 seconds.
· Two wire remote Start/Stop for use with ATS, Solar Charge Controller, Toggle Switch or other contact closure


Additional features
· User programmable durations and delays for all phases of startup and shutdown. Separate delay settings for Wi-Fi Start/Stop and 2 Wire Start/Stop
· Warm up
· Stop command to contactor open delay
· Cool down delay
· Wire harness uses Mil Spec Wire rated to 300F
· Antenna and connector are IP65 rated for water resistance
· Retains full manual control of the genset
· Controller is conformally coated to seal out moisture
· Includes Controller, wire harness, all hardware for installation & manual
· 1 year warranty


I personally assemble each of the Controllers and wire harness.
Once built each Controller is fully tested and calibrated.
Each wire harness is tested on a computer-controlled cable test system.


Ordering Information
Cost: $1,000 Includes USPS Priority Shipping in the US
PayPal & Checks accepted.

To order email me at: kurtklopp@gmail.com or PM me here on the forum
Be sure to include the following information:
1) Name & Mailing Address
2) Payment Method
4) PayPal email address if using PayPal


Controller Circuit Card Assembly

Card.jpg

Pre-Assembled wire harness
Harness.jpg

Complete with all Installation hardware and two drill bits
Hardware Kit.jpg

Sample web page when running under Wi-Fi control with live parameter reporting
Statistics (2).jpg



Sample phone screen of Min, Av, Max statistics table
History.jpg

Link to YouTube video about the system



Feel free to PM or email me with any questions!
 
Last edited:
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks