MEP-803a - Auto start and transfer

[kaletheriot]

New to the message board and new to my MEP 803a.

Looking for info on auto start and auto transfer with my 803. Had a Generac RXSW200A3 auto transfer switch installed. Also purchased and installed a 2 wire remote start controller kit for the generator. Both work great, but still working on the communication between the two.

If its already been done here, i don't want to try and reinvent the wheel. However, if not, i still have several questions with the T1, N1, N2, Ground, 12V and transfer control wire terminals in the generac transfer switch.

Let me know if there is info on this somewhere out there already!

If not, and knowledgeable folks want to help out, i can pass along my assumptions so far.

Thanks for the help!

 

[Scoobyshep]

I believe somebody here has already done the 803 to an ATS I did my 004 to a Generac ATS and I believe the N1 and N2 terminals are the normal Power detection points

Sent from my SM-S908U using Tapatalk

 

[kloppk]

PM sent

 

[Scoobyshep]

PM sent

I thought that was you but my brain is too far gone for the evening

Sent from my SM-S908U using Tapatalk