Need M880 key number!!

[citizensoldier]

Is there a M880 key number if so what is it? Alredneck is in need of it pronto! Help! lol

 

[citizensoldier]

bump

 

[papercu]

I only see a "B" on my key, it did work the key switch on both of my trucks. I'm going to town tomorrow and will try to have one made and send you a copy if that will help. Wayne

 

[citizensoldier]

I have a key for a M880 that I could mail him.. But I think Recovery 4x4 might have already done this.. We need the code number so he could have one made at a dealership or anyone close to Rock Island that has a M880 type vehicle? Hmmmm

 

[N1265]

The number on my key is : Y152

This is an aftermarket key and I am not sure it is the number you need...

 

[acmunro]

I guess I got lucky with my Dodge my ignition lock was in the lock position, but the steering and gearshift was not locked. A freind with a M886 gave me a key for it when I got it home.

 

[Alredneck]

Yea the key just locks the ignition. You can still shift it into neutral and steer the wheel. I will try that number key but we were hopping for a confirmation on what the code is. Recovery and everything I found on the net today said they all should be the same but noone has the code. Shhhh. Argghhh!!! I hate when this happens.

 

[54reo]

It's a MoPar, just jump the ballast resistor with 12 volts and bridge the starter relay.

 

[Alredneck]

Ah I was looking at that under the hood earlier today but wasnt sure if the ignition switch would keep cutting off the flow of juice. Will try it in the mornig, I got some spare wire and I always carry tools. Though I forgot my jumper cables and had to by new set. I can just bump it over with a screw driver at the relay after I get the 12vs to the positive side right. ( Just use a jumper wire to energize the side I need correct. I had to do that on my Jeep truck and a old F100 but its been a minute ) Thanks, Captain

 

[nattieleather]

The number on my key is : Y152

This is an aftermarket key and I am not sure it is the number you need...

That's the blank number that any key shop or hardware store will use to know to use a 1907s chrysler blank instead of a KW1 which is for a kwickset house lock etc.

What you need to find out is the cutting code the dealer would use to cut a new key. And yes one key fits them all. I might even have a M880 key at home....

 

[Hal_VT]

Did anyone come up with a key code yet?

I need either the code or a key, my key disappeared after my nephew's wedding in September, and I am going to need the truck pretty soon to plow snow.

 

[goodbrewing]

Where in Vt. are you? I have a spare and am in St. Albans.

 

[Hal_VT]

Goodbrewing, I am in Rochester.

Could you PM or email me, halh@sover.net and I could give you a mailing address.

 

[goodbrewing]

Goodbrewing, I am in Rochester.

Could you PM or email me, halh@sover.net and I could give you a mailing address.

Email sent