US6x4
Well-known member
- 1,264
- 2,329
- 113
- Location
- Wenatchee, WA
I need to know the torque specs for the (4) 1/4" bolts that secure the aluminum fuel button cover / housing to the PT pump. I can't find them anywhere - does anyone know?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Need torque spec for fuel button cover (PT pump)
- Thread starter US6x4
- Start date
- 8,642
- 2,987
- 113
- Location
- Monrovia, Ca.
72 INCH lbs, or 6 ft lbs
US6x4
Well-known member
- 1,264
- 2,329
- 113
- Location
- Wenatchee, WA
Thanks for the numbers Will. I looked through that TM Wes listed but it only mentioned torque values for some other bolts on the pump.
My problem is that it doesn't leak at idle or off-idle but it does at higher rpm while driving when I can't see it. There's actually fuel leaking everywhere since changing that button like at the cable shutoff valve on top and even on my dash oozing from the cold start primer pump...
My problem is that it doesn't leak at idle or off-idle but it does at higher rpm while driving when I can't see it. There's actually fuel leaking everywhere since changing that button like at the cable shutoff valve on top and even on my dash oozing from the cold start primer pump...