Doubled
New member
- 87
- 1
- 0
- Location
- Jonesboro, Arkansas
Are the following steps a correct procedure for replacing an "O" Ring on a M939 series 5 ton wheel?
If so are steps 6 and 7 in the right order?
Pics would be nice if you have them
Thanks!!
Double D
1. Deflate Tire
2. Remove the bolts holding the two halves of the rim together
3. Remove tire and bead lock from rim
4. Take off the old “O” ring and wire brush the groove where it goes
5. Coat the new “O” ring with a silicone based lubricant
6. Install the new “O” Ring
7. Put the tire and bead lock back on the rim
8. Put the rim back together
If new “O” Ring is to big dip in Cold water over it and if to small dip in Hot Water
If so are steps 6 and 7 in the right order?
Pics would be nice if you have them
Thanks!!
Double D
1. Deflate Tire
2. Remove the bolts holding the two halves of the rim together
3. Remove tire and bead lock from rim
4. Take off the old “O” ring and wire brush the groove where it goes
5. Coat the new “O” ring with a silicone based lubricant
6. Install the new “O” Ring
7. Put the tire and bead lock back on the rim
8. Put the rim back together
If new “O” Ring is to big dip in Cold water over it and if to small dip in Hot Water