Ok, I'm stuck....

[HitchMar Films]

This is in relation to my earlier posts about the Night Blind Mutt. I've made pretty good progress getting some light. I have headlights now and I've figured out why my gas gauge wasn't working. But....

Ok, I cannot figure this one out. I've ran the diagnostics per the manual and still can't figure out why I have no tail lights. I have power to the rear lights, I have brake lights and I have turn signals. However, I have no power to the tail lights sockets, and my rear black out lights don't work. Its as if the bulbs were burnt out, but I've swapped out with new. I've tested the master light control switch/box, power in, power out... And its just not one rear light, its both lights...


Are the tail lights grounded differently than the brake lights and turn signals? Does the turn signal control box have anything to do with the tail lights?


I'm stuck....


Thanks everyone!!!!


Chris...

 

[Recovry4x4]

If it's an A2 with composite lights, then both hold down bolts need to be grounded. Tail light circuit normally wouldn't go through the signal box.