• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Really loud on cold start

Bob H

Well-known member
Steel Soldiers Supporter
3,140
160
63
Location
Huron National Forest, Michigan USA
'84 M1009 60k on the clock

Apologize in advance if there's an easy to find thread on this issue, I searched, because I know it must have been covered here.

On cold starts, this things is scary loud clanking.
Quiets down after the fast idle(<-- wrong terminology) kicks off. Once warm it runs just as smooth & quiet as can be. (it is a 6.2)

Been a gasser guy, fairly new to this diesel stuff. Could this be an injection timing issue?
or should I be on the look out for a rebuild/new engine.
 

firefox

General
Steel Soldiers Supporter
1,845
51
48
Location
Berkeley CA
I would check all the glow plugs first, before worrying too much. If the truck
is new to you, then I would just replace all the glow plugs with AC60Gs just
to keep from visiting that problem in the future. Even if that doesn't turn
out to be the current problem. Check the CUCV stickies for further tips if you
haven't done so already.
 

m38inmaine

Well-known member
Steel Soldiers Supporter
2,112
64
48
Location
Maine USA
In the cold start cycle the timing is advanced so it sounds "knocky" until it kicks down off high idle.
 

rsh4364

Active member
1,372
15
38
Location
greensprings ,ohio
I remember my first coldstart experience,scared the heck out of me.I turned it off thinking I blew it up.I have learned a lot since then.I now run Rotella T-6,starts are much quieter now.Wait til you start it at -10 degrees.Really loud.
 
Last edited:

Barrman

Well-known member
5,259
1,769
113
Location
Giddings, Texas
Fast idle is the correct terminology. Two things happen when the coolant is below 95° in a properly working system.

The green wire at the IP has two ends. One of those ends goes to a solenoid inside the IP. That is the cold advance solenoid. It advances the timing to aid the engine in starting.

The other end on the green wire goes to the fast idle solenoid which is the round thing stuck up in the air next to the IP. When the driver turns on the ignition, the system is below 95° and pushes the throttle down an inch or so. The fast idle solenoid will hold the throttle open just a bit. Factory numbers on the air cleaner say 650 rpm warm and 800 rpm with fast idle.

The loud noise is almost all due to the advanced timing. The manuals don't state this, but driving easy until the advance turns off it probably a good idea.
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks