V8Merc124
New member
- 26
- 2
- 3
- Location
- Modesto California
Hi, I was installing some moog tie rod ends on an a1/a0 truck with a2 hubs and using the problem solver tie rods.
The canted angle is good on the hubs but the angle at the drag link seems rather tight? Picture attached.
Is this ok as I am installing the tie rod as it came out of the box. I didnt piece together the ends with an old tube. So this is a factory part.
Or is there a different drag center link to use the moog problem solver tie rods?
It seems a straighter rod end is better on the inside.
i know the a2 hubs have a straighter steering arm at the hub but that shouldnt change the angle at the drag link.
I thought i saw a thread about the canted angle rod ends but couldnt find it.
The canted angle is good on the hubs but the angle at the drag link seems rather tight? Picture attached.
Is this ok as I am installing the tie rod as it came out of the box. I didnt piece together the ends with an old tube. So this is a factory part.
Or is there a different drag center link to use the moog problem solver tie rods?
It seems a straighter rod end is better on the inside.
i know the a2 hubs have a straighter steering arm at the hub but that shouldnt change the angle at the drag link.
I thought i saw a thread about the canted angle rod ends but couldnt find it.
Attachments
-
87.2 KB Views: 24
-
57.3 KB Views: 24
-
85.8 KB Views: 24