WATER in "sealed" LED turn signal!

[rolling18]

how to get water out of upper amber portion of LED turn signal lens?

this area is sealed by a black epoxy from the back and unable to access w/o doing more damage.
i cant see where water would get in. there is about 1/2 inch water visible through lens.
(not the blackout section)
thanks!

 

[glcaines]

Drill a small hole in the bottom to let the water drain out. Since you don't know where the leak is, don't seal the hole and it will continue to drain future leakage.

 

[rolling18]

I was afraid I would have to do that.. but dont see any other option.

As suggested, i drilled the smalles hole i had a bit 1/16 i think...
any way, drilled through the epoxy near the edge of the light hoping i didnt hit any circuits
it worked! a small drip came out so I sucked the rest out got about 2 mouth fulls of water!! (not nasty either)

now I can use a very small screw to plug the hole since it will likley happen again
thanks