- 7,058
- 147
- 63
- Location
- Mid Hudson Valley NY
Any one have a clue as to the approximate weight of a M35A2 transmission? Can 2 guys pick one up?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Weight of M35A2 transmission?
- Thread starter emmado22
- Start date
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 755
- 113
- Location
- Cincy Ohio
Yes.
- 860
- 42
- 28
- Location
- Blaine, MN
I have loaded one in the trunk of a car before with one other guy no problem.
On a side note-gimp you have to change that avatar, it's like a car accident, I know I shouldn't look but I do and then wish I didn't
On a side note-gimp you have to change that avatar, it's like a car accident, I know I shouldn't look but I do and then wish I didn't
booger
Member
- 346
- 2
- 18
That avatar is gross...funny but gross
1crook
Member
- 221
- 0
- 16
- Location
- Bethlehem, GA
Two guys can definitely pick one up. One guy and one girl cannot, don't ask me how I know that one. 
Theres nothing funny about it. It's just gross. No idea where you dig these things up gimp, but your avatar pic's almost always make me shudder......
To the OP: I've manhandled the deuce tranny around by myself, and I'm not a big guy. Not sure I could have picked it up off the ground alone, but I moved it around.
To the OP: I've manhandled the deuce tranny around by myself, and I'm not a big guy. Not sure I could have picked it up off the ground alone, but I moved it around.
Last edited:
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 755
- 113
- Location
- Cincy Ohio
One man can pick up the trans.
- 6,986
- 2,522
- 113
- Location
- Montevideo/Uruguay
I suppose the problem wasn't the girl...???Two guys can definitely pick one up. One guy and one girl cannot, don't ask me how I know that one.
Transmission (drained, shifter off), W/O PTO: 220lb(100Kg)
W/ PTO: add 35lb(16Kg)
G.
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 755
- 113
- Location
- Cincy Ohio
ZING! Nice one G!
abh3
New member
- 236
- 3
- 0
- Location
- Florala, Al
Yeah, a strong guy can handle one but it's right on the edge of dumb, one mistake and you might regret it for a long time from what I know about back injuries.
Years ago an older buddy of mine drove up while I was wrestling a Ford FE V-8 around on a sheet of plywood by hand. He asked just what the &%^# I was doing when a diesel tractor stood there not 50 feet away. I explained how it was a pain, too much trouble, to put the boom on it for such a little job and then he told me about the little job that ruined his back, the pain, the failed operations, missed opportunities, etc., basically a life changing s%$t-storm from being too lazy to do it the smart way...
Years ago an older buddy of mine drove up while I was wrestling a Ford FE V-8 around on a sheet of plywood by hand. He asked just what the &%^# I was doing when a diesel tractor stood there not 50 feet away. I explained how it was a pain, too much trouble, to put the boom on it for such a little job and then he told me about the little job that ruined his back, the pain, the failed operations, missed opportunities, etc., basically a life changing s%$t-storm from being too lazy to do it the smart way...
- 14,639
- 4,817
- 113
- Location
- Buchanan, GA
I'm sure the problem in that situation was due to the guy part of the equation.Two guys can definitely pick one up. One guy and one girl cannot, don't ask me how I know that one.
- 7,584
- 363
- 83
- Location
- Cheyenne, WY
Now that was funny.
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 755
- 113
- Location
- Cincy Ohio
I suppose the problem wasn't the girl...???
Transmission (drained, shifter off), W/O PTO: 220lb(100Kg)
W/ PTO: add 35lb(16Kg)
G.
Welcome to the dept. of redundancy dept.!
- 14,639
- 4,817
- 113
- Location
- Buchanan, GA
Oops, I only noticed the technical blurb. 
1crook
Member
- 221
- 0
- 16
- Location
- Bethlehem, GA
I won't throw Clinto under the bus. It was too heavy for me to lift. The 6tl's are heavy, but the transmissions are too much to lift without some help.
Funny post though G.
You forgot to add how much the bell housing weighs also if it is still attached. We were able to manuver one transmission around without the bell housing attached, but the one that still had one attached was too much weight for me to attempt to lift with him (he had to find another soldier B to assist). As much as I hate to say it, I guess this is one of the rare instances when I agree with Clinto in that we need a wrecker. Time to get my head checked. 
Funny post though G.
You forgot to add how much the bell housing weighs also if it is still attached. We were able to manuver one transmission around without the bell housing attached, but the one that still had one attached was too much weight for me to attempt to lift with him (he had to find another soldier B to assist). As much as I hate to say it, I guess this is one of the rare instances when I agree with Clinto in that we need a wrecker. Time to get my head checked.
- 14,639
- 4,817
- 113
- Location
- Buchanan, GA
clintogf = soldier A
clinto = soldier B
clinto = soldier B
1crook
Member
- 221
- 0
- 16
- Location
- Bethlehem, GA
I think that is how Clinto explains it too Patracy.
Capt.Marion
Active member
- 1,811
- 15
- 38
- Location
- Atlanta, GA
Glad to hear that you've got him trained... now y'all just need to work in Brian a bit more.
- 2,960
- 30
- 48
- Location
- Tiro, Ohio
Gimp claims a multifuel crankshaft is kinda of heavy.... Transmission is heavy, but you can move it around. I use two people also.
- 6,986
- 2,522
- 113
- Location
- Montevideo/Uruguay
Well, what I stated was complete WITH the bellhousing & clutch actuating parts attached; since that's how they normally are moved around.
G.