joeypushjr1
New member
- 367
- 1
- 0
- Location
- tallmadge ohio
well its probally not a big oooo ahhhhhh but hey ill post something anyway. i finially installed my 24v fan in the deuce today. mounted it between the 2 windows sits perfect. can aim at both windows or myself or circulate threw out the cab. now i purchased this thing on Egay . stating it was 12-24v fan. and the papers say the same but the only marking on the dimming switch says 12v. well ok so i instaled it ran some automotive wire mold down the the base as you can see in the pic. and just to left of clove box i knocked out the 1/2" KO plug and installed the speed knob. found a power source under dash. (power to the heater) hooked her up ran like a charm but didnt run long. so i drove the truck cause i was bored and ran the fan . reallly nice . ok smoke comming from fan switch knob. dangit... apperently it like the fan isnt 12-24v. cause 24v. was just too much for it to handle. so joe thinks hes going to go get a resister to knock the power down right before the switch. and try it again. cause buying a 24v switch will be way more then this resister... just thought id share this little bit with yall.. thanx for letting me ramble on lololol
Attachments
-
36.8 KB Views: 56
-
75.3 KB Views: 58
-
41.2 KB Views: 52