Csm Davis
Well-known member
- 4,166
- 393
- 83
- Location
- Hattiesburg, Mississippi
What would cause the cam to push toward hard enough to bust the cover but the motor still runs ?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
250 cam thrust plate and timing cover busted
- Thread starter Csm Davis
- Start date
wreckerman893
Possum Connoisseur
- 15,629
- 2,054
- 113
- Location
- Akenback acres near Gadsden, AL
Operator head spacing and timing?
Csm Davis
Well-known member
- 4,166
- 393
- 83
- Location
- Hattiesburg, Mississippi
funny guy
Only if you are the operator wreckerman!Operator head spacing and timing?
Csm Davis
Well-known member
- 4,166
- 393
- 83
- Location
- Hattiesburg, Mississippi
Hey any ideas on this?
- 12,195
- 325
- 0
- Location
- gainesville, ga.
Wrong thrust washer spacing, according to the TM, there is Two different cam thrust designs
From tm-9-2320-160-34-1, page 3-208
"Measure shim(s) (12) as a pack with micrometer. Add or subtract shim(s) (12) from pack to provide
a clearance of 0.001-0.005 in. (0.0254-0.127 mm) for engines with camshaft thrust plate or
0.008-0.013 in. (0.2032-0.3302 mm) for engines with camshaft outboard bearing support".a clearance of 0.001-0.005 in. (0.0254-0.127 mm) for engines with camshaft thrust plate or