Shop Rat Fab
Member
- 99
- 2
- 8
- Location
- Detroit, Michigan
Mine looks like it was a chaplans unit and had crosses on the doors.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Cucv door markings
- Thread starter airbornebandsman
- Start date
MSgt USMC (Ret)
New member
- 100
- 8
- 0
- Location
- Concord, NC
That's a Center of Balance or C/B marking. It was required for movement by air. That marking would be about the center of balance for a CUCV. Normally units would use masking tape to mark the "CB" as it would likely move a few inches from embarkation to retrograde depending on the cargo load
Chaplains attached to USMC units rarely if ever had a dedicated vehicle. If they needed to get around the CO's vehicle would commonly be used.
lindyp38
New member
- 788
- 0
- 0
- Location
- ulster county ny
where can i get the stencil for ....official use only ....thanks mario
ABN173
Active member
- 1,842
- 11
- 38
- Location
- FT Bragg, NC
Mario,
Most of the ones I have seen are " FOR OFFICIAL USE ONLY" also for mine it was vinyl lettering rather than a painted stencil.
-Dale
Oh yeah I doctored mine some.
Attachments
- 2,186
- 86
- 48
- Location
- Zimmerman MN
HAHA I love that. What color paint or vinyl lettering would be appropriate for woodland camo?
dependable
Well-known member
- 1,720
- 188
- 63
- Location
- Tisbury, Massachusetts
Uncovered this on my M1031. The plate shows door was originally in a m1008. High mortality rate on 1031 doors? Like they did not chock it when running PTO.
I believe IFOR was the 'stabilization force' in Bosnia.
I believe IFOR was the 'stabilization force' in Bosnia.
Attachments
dependable
Well-known member
- 1,720
- 188
- 63
- Location
- Tisbury, Massachusetts
Took me a while to find this picture. This Blazer came from GL in 2010. It is pretty faded, but have seen pictures of this marking with tape on other tan trucks in 'Dessert Storm.'
Attachments
- 4,218
- 3,262
- 113
- Location
- Near Austin, Texas
Per the manual- black on green/brown areas, green on black areas.
Cheers
PS added pics for example. Marine CUCV's often had the USMC###### on the door just above the crease line. Also, the Marines usually write the tire pressure as ##PSI, though they do use TP## also.
Attachments
Last edited:
Haweneyu
New member
- 6
- 0
- 0
- Location
- Laurelville, Ohio
My 86 CUCV M1009 has the word "STAMPER" on the drivers door just below the window. Not sure what it means though.
A while back at Mechanicsburg I was doing a pick-up in the yard and had seen a sand colored blazer that had a VERY well done skull and crossbones on the doors.......I'd have bought it just for that reason!...cooooolll !!
dc9137
New member
- 123
- 0
- 0
- Location
- Rogers, AR
That's probably the nickname of the guy who drove it. Mine had Bob "Goat" in the same place...
combatmech
Active member
- 1,213
- 5
- 38
- Location
- Carrollton, Texas
Saw a M1009 on GL a while back, it had "Stuffed Crust" painted on the hood and tailgate. Odd paint job as well...Kind of desert, kind of woodland.
These pics are of my cucv they tried to cover with spray paint but you can see markings if you zoom in
Attachments
acthomp781
Member
- 79
- 30
- 18
- Location
- Massillon, OH
This is a picture of my M1009 . I remember the M1008's I saw when I was active in the USMC In the early 90's, and the door markings were similar to what I did on mine. At least the way I remember. The 2nd one is one I found on the internet.
