tmaxxgod4
Member
- 83
- 0
- 6
- Location
- anaheim ca
I took my M923A2 on freeway about 20 miles and it did 70 MPH then when I got into town I noticed it leaked a lot of oil but oil pressure was not bad. so when I drove back on the same freeway the 20 miles it would only go 50 55 pushing it.. and i tried over other roads it will not go over 55 no mater what.
O and after my trip to town and back I added 1 gal oil that it was low.
so to try and fix leak I added lucus stop leak as well. (it still leaks)
so why did I lose so much power? did I mess something up..
ALSO another problem is after it sits for a few days it wont start I have to give it lots of gas and even after it starts I put my foot to the floor and it just barley ideles for about a min or so then I get the response from the gas peddle. and it blows out lots of white smoke (this is all after siting got 3 days or more)
oil pressure at idle is under 30psi and at full 2000 rpm (not moving) my oil pressure is 60psi. and thats at temp almost 200
O and after my trip to town and back I added 1 gal oil that it was low.
so to try and fix leak I added lucus stop leak as well. (it still leaks)
so why did I lose so much power? did I mess something up..
ALSO another problem is after it sits for a few days it wont start I have to give it lots of gas and even after it starts I put my foot to the floor and it just barley ideles for about a min or so then I get the response from the gas peddle. and it blows out lots of white smoke (this is all after siting got 3 days or more)
oil pressure at idle is under 30psi and at full 2000 rpm (not moving) my oil pressure is 60psi. and thats at temp almost 200
Last edited: