Stein12501
Member
- 190
- 4
- 18
- Location
- Tebbetts, MO.
This is why I love this site. Thanks for the info!!!
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Trailer it ... what trailer?
- Thread starter chickendumpling
- Start date
- 7,584
- 363
- 83
- Location
- Cheyenne, WY
But the Hummer H1 is in their system and isn't allowed to tow it.
Blackmagic94
Member
- 468
- 9
- 18
- Location
- Oro Valley/AZ
Exactly because it's weight exceeds the rating of the trailer.
NCBPhantom
Member
- 39
- 0
- 6
- Location
- Danbury, CT
Would it be easier to use a U-Haul trailer or a larger open deck type trailer? Would be towing with a 1-ton GMC dually.
Jakob1944
New member
- 314
- 10
- 0
- Location
- Copperas Cove / Texas
Boy that's a tight fit......
Stein12501
Member
- 190
- 4
- 18
- Location
- Tebbetts, MO.
I rented a flat trailer to haul mine. Brought it back pulling it with a 3/4 ton dodge from New Jersey and had no problems. They are wide and pretty heavy. Good Luck!!
NCBPhantom
Member
- 39
- 0
- 6
- Location
- Danbury, CT
I'll be traveling west from Connecticut to Ohio and back. Just trying to do it the most economical and safe way possible. I've done over the road hauling in the military so it won't be my first rodeo.
Stein12501
Member
- 190
- 4
- 18
- Location
- Tebbetts, MO.
I too was going to rent the U-Haul trailer but for a long and rough road (Penna Turnpike) I went with a 20' equipment trailer. Cost a little more but for me it was worth it. The hills and turns the thing rode like a champ. The 82" wide wheel base will just barely go between wheel wells and it takes every inch of the U-Haul trailer. They're guys that have done it with no problems but for me I went with the larger trailer. Mine was not a runner so getting it on the trailer was the biggest problem I had. I owned a flatbed and hauled steel so like you it was not my first rodeo either. Just take your time and stop and check it often and you'll have a trip you'll remember for a lifetime.
Jakob1944
New member
- 314
- 10
- 0
- Location
- Copperas Cove / Texas
When did yours close?.......mine closed on 09.14.16.....maybe I'll get mine this year
NCBPhantom
Member
- 39
- 0
- 6
- Location
- Danbury, CT
6.28.16 it s my first one still waiting on my euc to clear. Hoping to grab it before Thanksgiving so I can avoid a freezing cold recovery.
TucsonVTXF
Member
- 308
- 1
- 18
- Location
- Tulsa, OK
no different than me in a speedo or spandex!!!
Jakob1944
New member
- 314
- 10
- 0
- Location
- Copperas Cove / Texas
Bet yours will be along right soon....
NCBPhantom
Member
- 39
- 0
- 6
- Location
- Danbury, CT
Yup cleared yesterday thankfully
Jakob1944
New member
- 314
- 10
- 0
- Location
- Copperas Cove / Texas
Congrats....What is it and how far away is it.....will it crank and run
NCBPhantom
Member
- 39
- 0
- 6
- Location
- Danbury, CT
Its an M998. Needs batteries to run and its about 500 miles away for me.
Jakob1944
New member
- 314
- 10
- 0
- Location
- Copperas Cove / Texas
I hope you get away with just needing batteries.....
desmodromic
Member
- 235
- 22
- 18
- Location
- New York, New York
I have hauled twice with the 7500# Uhaul trailer, once from Fort Meade and again from the Whitehall DLA site (essentially the same route as you). I would definitely opt for a wide deck/deck over equipment trailer. It really is like squeezing a fat girl in a little dress with the uhaul trailer and I cut a sidewall from rubbing on the trailer inner fender. YMMV.
nspctr1
Member
- 187
- 6
- 18
- Location
- San Antonio TX
SO, not to beat a dead horse but , where are you guys finding these equipment trailers to rent?
infidel got me
Well-known member
- 1,679
- 32
- 48
- Location
- Newberry, Florida
Uhaul--- I don't think they rent equipment trailers..... Any tool rental place should rent the trailer you need.