HelluvaEngineer
Active member
- 191
- 82
- 28
- Location
- Atlanta, GA
For some reason the tow ball is missing on my pintle hook assembly in my m1009. I'd love to put a 2" ball on there. Has anyone had any luck finding a good match? The shank diameter is pretty close to 1.25 inches but not quite for some reason.
I tried this model and it doesn't quite fit in the bore. http://www.curtmfg.com/part/40090
I am considering trying a cylinder hone to clean it up just a bit but want to make sure I'm not missing something obvious.
I tried this model and it doesn't quite fit in the bore. http://www.curtmfg.com/part/40090
I am considering trying a cylinder hone to clean it up just a bit but want to make sure I'm not missing something obvious.