- 95
- 49
- 18
- Location
- Sussex New Jersey
My M1028 ended up on the back of a tow truck today. The problem started yesterday on a trip to West Point in New York. I topped off the tank with 10 gallons of diesel and headed out. About 40 miles into the ride the truck lost power and started letting out blue smoke from the tailpipes. It stalled a couple times but started right up both times. I pulled over and I added some winter Diesel Kleen and let it idle for about 10 minutes. After that it ran fine the rest of the way, about 15 or 20 miles. It was about 10 degrees out.
This morning it was 4 degrees when I started the truck. It had not been plugged in all night. It started ok and ran fine for about 40 miles again when it lost power again and stalled. It restarted and I drove about 5 more miles. After that it would not stay running for more than a minute. As of now it's plugged in until I can see if it will run tomorrow and change out the fuel filter.
I hoping it is just gelled up but I don't understand why it would gel after driving 40 miles. Is that possible or am I looking at a new fuel pump or injector pump?
This morning it was 4 degrees when I started the truck. It had not been plugged in all night. It started ok and ran fine for about 40 miles again when it lost power again and stalled. It restarted and I drove about 5 more miles. After that it would not stay running for more than a minute. As of now it's plugged in until I can see if it will run tomorrow and change out the fuel filter.
I hoping it is just gelled up but I don't understand why it would gel after driving 40 miles. Is that possible or am I looking at a new fuel pump or injector pump?