- 112
- 69
- 28
- Location
- Coppell, Texas
Thank you for accepting me as a new member. New owner of a late 90's M1123, about to undergo a 4 door conversion, paint, and more. Look forward to learning from everyone here and meeting some other locals.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
New member from Dallas/Ft. Worth area - New M1123 Owner
- Thread starter tjonesdfw
- Start date
twisted60
Well-known member
- 617
- 250
- 63
- Location
- Jupiter, Florida
Welcome, you'll find lots of great info here, if you haven't downloaded the TM's (manuals) do so you'll learn a lot.
m715mike
Well-known member
- 2,797
- 3,823
- 113
- Location
- Montgomery, Texas
Howdy from just north of Houston. Welcome to the site.
If you get the opportunity, please post some pictures of your MV!
As for meeting some locals, I’m sure @fuzzytoaster will post soon….
If you get the opportunity, please post some pictures of your MV!
As for meeting some locals, I’m sure @fuzzytoaster will post soon….
- 2,053
- 2,949
- 113
- Location
- Florence, SC
Welcome to the site!
- 4,300
- 3,132
- 113
- Location
- Fort Worth, Texas
Howdy and welcome!
- 18,541
- 5,848
- 113
Welcome aboard 
Find a bunk, stow your gear, and prepare to get underway
.
Find a bunk, stow your gear, and prepare to get underway
.
OliverLove
New member
- 5
- 16
- 3
- Location
- Denton, TX
Welcome! I'm up in Denton, give a shout if you need help.
- 7,716
- 19,766
- 113
- Location
- Charlotte NC
.
Like all the other guys mentioned - Welcome to the outfit!
There are lots of good folks out there in Texas that have MVs and are willing to point you in the right direction for parts and information. As mentioned, grab a bunch of pictures of your New-To-You vehicle and post them for the rest of us to oogle. You will find the TM's (already mentioned) handy. Incredibly DRY reading but there is a -10 that is the owners manual and a -24 that will help you find part numbers. There are flow charts on how to solve a problem that will point you to a solution faster than just staring at the problem.
Again, welcome to the site and congratulations on your new member of the Big Green and Tan family!
- 112
- 69
- 28
- Location
- Coppell, Texas
Attachments
Last edited:
- 112
- 69
- 28
- Location
- Coppell, Texas
Here’s the final batch of photos
Attachments
- 112
- 69
- 28
- Location
- Coppell, Texas
Initial findings….
Surge on cold start. Voltage gauge bounces back and forth in the green range for several minutes while the engine surges in sync with the gauge moving. Once it warms up, this eventually stops and gauge settles in the green.
Leaking rear diff (I think) at passenger side seal behind the brake rotor. Gets worse after a drive. Fluid is greenish… maybe water intrusion? Pretty decent leak.
Leaking fuel pump, see photos. Pretty wet on the underside of the pump.
Aftermarket Midwest top and x doors from prior years, marked as ‘92. All for sale soon!
Leaking fuel tank at filler neck or sender… no access panel in the tunnel
Holes all over from the MAK upfit in ‘09. Worst are the ragged ones on the top of the bedsides/rear fenders. Any ideas how to cover these up. Didn’t see when I purchased with the troop seats down.
Leak in the Red Dot
Shoulder belts don’t retract
Surge on cold start. Voltage gauge bounces back and forth in the green range for several minutes while the engine surges in sync with the gauge moving. Once it warms up, this eventually stops and gauge settles in the green.
Leaking rear diff (I think) at passenger side seal behind the brake rotor. Gets worse after a drive. Fluid is greenish… maybe water intrusion? Pretty decent leak.
Leaking fuel pump, see photos. Pretty wet on the underside of the pump.
Aftermarket Midwest top and x doors from prior years, marked as ‘92. All for sale soon!
Leaking fuel tank at filler neck or sender… no access panel in the tunnel
Holes all over from the MAK upfit in ‘09. Worst are the ragged ones on the top of the bedsides/rear fenders. Any ideas how to cover these up. Didn’t see when I purchased with the troop seats down.
Leak in the Red Dot
Shoulder belts don’t retract
Attachments
- 112
- 69
- 28
- Location
- Coppell, Texas
Pics are up now!
- 112
- 69
- 28
- Location
- Coppell, Texas
Thank you! Pics are up finally..
Like all the other guys mentioned - Welcome to the outfit!
There are lots of good folks out there in Texas that have MVs and are willing to point you in the right direction for parts and information. As mentioned, grab a bunch of pictures of your New-To-You vehicle and post them for the rest of us to oogle. You will find the TM's (already mentioned) handy. Incredibly DRY reading but there is a -10 that is the owners manual and a -24 that will help you find part numbers. There are flow charts on how to solve a problem that will point you to a solution faster than just staring at the problem.
Again, welcome to the site and congratulations on your new member of the Big Green and Tan family!
- 7,716
- 19,766
- 113
- Location
- Charlotte NC
.
I dropped in a link for your new pix.
New member from Dallas/Ft. Worth area - New M1123 Owner
Thank you for accepting me as a new member. New owner of a late 90's M1123, about to undergo a 4 door conversion, paint, and more. Look forward to learning from everyone here and meeting some other locals.
www.steelsoldiers.com
- 112
- 69
- 28
- Location
- Coppell, Texas
I've found M998 TM's but can't seem to find the A2/M1123 TM's. Probably newbie user error, but could you point me towards the correct TM's by chance? Thank you!
twisted60
Well-known member
- 617
- 250
- 63
- Location
- Jupiter, Florida
I have an M1152, Just did a quick search and did not find any M1123 tm's, that said I bet any 11 series tm should work, some accessories will be different, but general maint should be the same.
KS_Patriot
Active member
- 84
- 188
- 33
- Location
- Eastern Kansas, USA
Welcome
- 481
- 1,112
- 93
- Location
- AL
Several of the applicable TM’s are listed here …..
Humvee Manuals Download – HMMWV Manual Links | Gear Report
HMMWV manuals to download for free in .pdf form
gear-report.com