- 7,716
- 19,766
- 113
- Location
- Charlotte NC
.
Dang Right! Sharp - and even sharper as a junk yard find!
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
84 m1009 cucv chevy blazer build-up
- Thread starter 2INSANE
- Start date
Dang Right! Sharp - and even sharper as a junk yard find!
2INSANE
Well-known member
- 725
- 824
- 93
- Location
- Belgrade, Montana
37/12.5/r16.5 New MTRs arrived today. My 10” wide 16.5 rims were too wide and every once and awhile a bead would come off with low tire pressure. So I plan on finding some OEM 16.5 rims for this set. This set will be my main off road set.
Attachments
2INSANE
Well-known member
- 725
- 824
- 93
- Location
- Belgrade, Montana
Quick update!
The remote oil cooler arrived!
Something I have always wanted for over 10 years and I am finally getting it! Trailworthyfab beadlocks with pvc inserts! Yep! They are on the way! The Antifreeze Green adds 5hp if yal did not know!
My first wife would have not approved on any of my spending habits over the last year. Luckily I got divorced and the new wife is all for the bad ass mods!
The remote oil cooler arrived!
Something I have always wanted for over 10 years and I am finally getting it! Trailworthyfab beadlocks with pvc inserts! Yep! They are on the way! The Antifreeze Green adds 5hp if yal did not know!
My first wife would have not approved on any of my spending habits over the last year. Luckily I got divorced and the new wife is all for the bad ass mods!
Attachments
- 7,716
- 19,766
- 113
- Location
- Charlotte NC
.
Good for you! Happy to have new toys on the way to you soon.
Congratulations on the wonderful woman too!
2INSANE
Well-known member
- 725
- 824
- 93
- Location
- Belgrade, Montana
Remote oil cooler installed in the rear underneath. It clicks on at 180 degrees now. Lowered the oil to 220 degrees when pulling 6% grade.
Also got the Trailworthyfab beadlocks on the blazer. At 55mph it vibrates a little, even with 10oz of dynabeads in each tire. I will add more dynabeads in the near future and get alignment done.
Also got the Trailworthyfab beadlocks on the blazer. At 55mph it vibrates a little, even with 10oz of dynabeads in each tire. I will add more dynabeads in the near future and get alignment done.
Attachments
2INSANE
Well-known member
- 725
- 824
- 93
- Location
- Belgrade, Montana
I started the th400 to 700r4 swap by dropping both th400 and np208 yesterday.
If I get 10 likes, I will do a full detailed wright up on the 700r4 swap
If I get 10 likes, I will do a full detailed wright up on the 700r4 swap
Attachments
2INSANE
Well-known member
- 725
- 824
- 93
- Location
- Belgrade, Montana
Need 2 more likes on post #426 by this Saturday morning!
2INSANE
Well-known member
- 725
- 824
- 93
- Location
- Belgrade, Montana
Ok gentlemen, I got the swap in progress!
The One Stop 700R4 Swap M1009
Overview Please give many thanks to the 10+ SS members for giving me the motivation to create this thread. Chuckg, 4sdair, forest522, computer54, dezertdemond, Dsilverline, Chevymike, ssdvc, TheMod, Mullaney, royalflush55, 1love, Sharecropper… By popular demand! This is a REAL M1009 1984...
www.steelsoldiers.com
2INSANE
Well-known member
- 725
- 824
- 93
- Location
- Belgrade, Montana
I got my poor mans winter front grill cover on today. Gives about 15-20 degrees of more heat
Also used one of those tower drill bits and drilled a hole into the 6.5 intake rubber elbow to install the air filter indicator.
While I had the air filter box off, I checked the filter and found a rock and some bugs went into the snorkel and got trapped in the filter. So to prevent this from happening again, I just ordered a cheap $15 pre filter.
Since it is getting cold here in Montana, -29 f, I installed the dual battery warmer blankets that I had before the motor swap. It really makes a huge difference with cold cranking amps not being reduced from the cold. Using a 3 prong heavy duty extention cord, I can have both battery warmers and freeze plug block heater working at the same time.
Also wired up the 6.5 oil pump gear drive with tach sensor to the tachometer. Works perfectly! I grounded the ground to the back of the firewall utilizing the already existing bolt holes where the glow plug resisters were and the white wire went straight to the tachometer wire. Very simple.
Also used one of those tower drill bits and drilled a hole into the 6.5 intake rubber elbow to install the air filter indicator.
While I had the air filter box off, I checked the filter and found a rock and some bugs went into the snorkel and got trapped in the filter. So to prevent this from happening again, I just ordered a cheap $15 pre filter.
Since it is getting cold here in Montana, -29 f, I installed the dual battery warmer blankets that I had before the motor swap. It really makes a huge difference with cold cranking amps not being reduced from the cold. Using a 3 prong heavy duty extention cord, I can have both battery warmers and freeze plug block heater working at the same time.
Also wired up the 6.5 oil pump gear drive with tach sensor to the tachometer. Works perfectly! I grounded the ground to the back of the firewall utilizing the already existing bolt holes where the glow plug resisters were and the white wire went straight to the tachometer wire. Very simple.
Attachments
2INSANE
Well-known member
- 725
- 824
- 93
- Location
- Belgrade, Montana
The snorkel pre filter arrived. Also got the beadlocks off and slapped the new tires on the old aluminum rims.
Attachments
2INSANE
Well-known member
- 725
- 824
- 93
- Location
- Belgrade, Montana
This weekend I am going to take it on a nice 700 mile run as a Maiden Voyage with the new motor, trans and t case. I will report back the stats and mpg. I’ll haul butt on the way there and do a 65 mph way back towing a 2000 pound pop up camper which is going to be the next off road camper build.
2INSANE
Well-known member
- 725
- 824
- 93
- Location
- Belgrade, Montana
When it gets super cold, -10 threw -30 f, I remove the 4x 13mm nuts that hold the fan on and take the fan off. Doing this helps. Just gotta keep your eyes constantly on the temp gauge. I also wear a -30f jump suit with boots as seen in the pic.
Attachments
2INSANE
Well-known member
- 725
- 824
- 93
- Location
- Belgrade, Montana
Heck yeah! I have not heard about electric socks. They work good? I usually just wear a nylon socks under a pair of wool socks and that usually keeps the feet warm and dry.
Yeah, some of the motorcycle shops sell higher end electric clothing, including jackets, gloves, sock, etc. Bought my wife an electric vest (little 7.2v battery) and it will keep her very toasty in sub-zero temps for about 4 hours on high. She loves it !
2INSANE
Well-known member
- 725
- 824
- 93
- Location
- Belgrade, Montana
Here are the stats from this weekends 760 mile round trip.
50mph @ 1500rpm
55mph @1700 rpm
60mph @1800 rpm
65mph @1900 rpm
70mph @2100 rpm
75mph @2250 rpm
80mph @2350 rpm
85mph @2500 rpm
(Not towing hauling ass 70-80mph average range 650-900 degrees 9 psi boost)
First fill up 15 gal 242 miles 15.1287 mpg
(Towing pop up camper hauling ass 70-80mph average range 650-900 degrees 9 psi boost)
Second Fill up 16 gal 176 miles 10.87 mpg
(Towing pop up camper 40-65 mph average mountainous egg range 650-900 degrees 6-9 psi boost)
Third Fill up 14 gallons 206 miles 14.71 mpg
Also when I got 1/2 way to my destination, I checked the motor and found that the ARB snorkel is restricting air flow to the motor. I disconnected it and the added air gave more power, lower egts and better MPG on the mountainous terrain.
Basically, the ARB snorkel does not work for our turboed diesels.
50mph @ 1500rpm
55mph @1700 rpm
60mph @1800 rpm
65mph @1900 rpm
70mph @2100 rpm
75mph @2250 rpm
80mph @2350 rpm
85mph @2500 rpm
(Not towing hauling ass 70-80mph average range 650-900 degrees 9 psi boost)
First fill up 15 gal 242 miles 15.1287 mpg
(Towing pop up camper hauling ass 70-80mph average range 650-900 degrees 9 psi boost)
Second Fill up 16 gal 176 miles 10.87 mpg
(Towing pop up camper 40-65 mph average mountainous egg range 650-900 degrees 6-9 psi boost)
Third Fill up 14 gallons 206 miles 14.71 mpg
Also when I got 1/2 way to my destination, I checked the motor and found that the ARB snorkel is restricting air flow to the motor. I disconnected it and the added air gave more power, lower egts and better MPG on the mountainous terrain.
Basically, the ARB snorkel does not work for our turboed diesels.
SomeNewGuy
Member
- 59
- 95
- 18
- Location
- VA
So I've had my 1009 for about... 5 months? Havent played with the fuel or timing or anything, fuel guage does not work so I fill it up every time I am on my way home from work.
Goin about 85 miles, I keep putting in only 3-3.5 gallons per fill.... meaning 24-28 mpg...
With such drastic differences in mpg between us... I can't help but think something may be wrong on my end? I fill up till the breather is coughing up diesel...
Edit: Or is the turbo what the big difference is?
Goin about 85 miles, I keep putting in only 3-3.5 gallons per fill.... meaning 24-28 mpg...
With such drastic differences in mpg between us... I can't help but think something may be wrong on my end? I fill up till the breather is coughing up diesel...
Edit: Or is the turbo what the big difference is?