Hello all, I am trying to get my hood lights done correctly. My hood wires were cut before the canister plugs. I got new canister plugs and a pair of 12469143 harnesses. Does anyone have a functional diagram of this harness? I have a parts diagram from the TM but that doesn’t help me Much.
i am trying to determine which wire is hot using the multimeter and different light switch configurations.
i know there is:
light on
signal (found this wire)
blackout light (left side only)
IR light
side marker? (might be tied to the light on wire)
ground (might be tied to the frame instead of a wire)
i don’t fully understand how each wire signal is setup so any input would be nice.
i am trying to determine which wire is hot using the multimeter and different light switch configurations.
i know there is:
light on
signal (found this wire)
blackout light (left side only)
IR light
side marker? (might be tied to the light on wire)
ground (might be tied to the frame instead of a wire)
i don’t fully understand how each wire signal is setup so any input would be nice.