- 16,716
- 23,970
- 113
- Location
- Burgkunstadt, Germany
Normally, it is not a failed coil. Its that these things are notable for getting moisture in them, and then they kinda rust up. Mostly easy to correct. If its broke, you can't make it broker.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
804A power transfer issue
- Thread starter DBLE
- Start date
DBLE
New member
- 17
- 13
- 3
- Location
- Acworth, NH
Good morning Guy,
All the more reason to get this genset under cover. Weather here this morning looks a bit ominous, but the investigation exercise shouldn’t take all that long. I’ll report back.
DBLE
New member
- 17
- 13
- 3
- Location
- Acworth, NH
Guy,
No voltage at X,Y at K1, with Main SW in run position, battle short on, S5 Up, To ensure the contactor was in good shape, I removed it. Was a bit sticky, No sign of any water or rust, contacts needed dressing up. Coil measured 43 ohm. Ran out of daylight, will test coil / contactor with 24 VDC from battery in the Am. ( 24vdc applied across X,Y AT K1) 7-1/2 Control fuse appears to be a re-setable type, doesn't appear to be popped out (tripped) the other 2 fuses are good.
Any thoughts on next steps?
- 16,716
- 23,970
- 113
- Location
- Burgkunstadt, Germany
Have you bench tested the K1? If so, what happened?
If it works, Make sure S5 is wired like this. Then remove wire 140D. Measure from that wire to wire #240A, at the K1. Also remove that wire, so you are only measuring the wire, not the K1. What you get?
If it works, Make sure S5 is wired like this. Then remove wire 140D. Measure from that wire to wire #240A, at the K1. Also remove that wire, so you are only measuring the wire, not the K1. What you get?