combat32
Well-known member
- 1,639
- 106
- 63
- Location
- Booneville AR.
Started the dissasembly of my free winch, it is locked up tight.Now that I have it apart a bit I can see why.The clutch side was full of water, I bet the drive side is too.I have all new seals on the way.My question is what is a good technique for gettin those woodruff keys out on the shaft so I can remove the thrust bearing and then the drum.I have TM in hand but it is a bit vague, it says remove and discard, I would kind of like to reuse them as I have no replacements.
Any advice is appreciated, here are a couple of pics of my progress so far,
Any advice is appreciated, here are a couple of pics of my progress so far,
Attachments
-
60.9 KB Views: 76
-
91.4 KB Views: 76
-
76 KB Views: 74
-
98.5 KB Views: 75