PTO stud lengths

[Tackettr]

Does any one know the length of the studs for the winch PTO? I'm guessing 1 1/4 "? Maybe 1 3/8"? Also, are they 3/8" NC on both sides or separated then 3/8" NF on the end for the nut? Thanks for any help. I'm hoping I get some at NAPA today.

 

[gringeltaube]

Total lenght: 1 1/2"
Diameter: 3/8"
Threaded end, transm. side: 3/8"-16 x 1/2"L (+/- 1/16")
Threaded end, PTO side: 3/8"-24 x 5/8"L (+/- 1/16")

G.

 

[Tackettr]

G.
Thanks so much!!

 

[AceHigh]

Just a heads up- I found them in stock at Tractor Supply.

 

[Tackettr]

Thanks Ace! Will check there first, I bet they are a little cheaper too!

 

[AceHigh]

Not bad. They were in the sliders with the stainless and metric stuff. Only had 5 but I bought one that was 1/4" too long and shortened it to correct size.

 

[AceHigh]

For reference Gringletaube had an excellent photo of the stud in this earlier thread.

http://www.steelsoldiers.com/deuce/31561-pto-stud-size.html

 

[gringeltaube]

...................... photo of the stud in this earlier thread.

Hey, you beat me on this....
Guess I should have done a previous search, too... since I'm getting old and forgetting what I had already posted...!

Mods/ admins: This is a typical case for two threads to be merged into one, I think.

Tks
G.

 

[Warthog]

Does any one know the length of the studs for the winch PTO? I'm guessing 1 1/4 "? Maybe 1 3/8"? Also, are they 3/8" NC on both sides or separated then 3/8" NF on the end for the nut? Thanks for any help. I'm hoping I get some at NAPA today.

Did M1075 still have the pto shaft at the shop?

 

[Tackettr]

Man I suck with the search engine on here! I did an "advance search" limited to the duece forum for "PTO Studs", no hits. Then "PTO" and got hundreds, gave up after a couple of pages this morning. Sorry guys! Thanks for the help and pics. I just cleaned out TSC's supply of them during lunch.

Warhog: Yes, got the drive shaft. It's missing the slip yoke and has a big dent and warpped. Not sure if it will be cost effective to rebuild it or not? Thanks anyway!

 

[clinto]

Just an FYI:

Fastenal has the studs. Sold in a 10 pack (you'll end up with extras for your other deuces! ).

The Fastenal part #: 11105070
The Fastenal cost for the 10 pack: $8.97

The Au-Ve-Co ( Auveco ) part # is 9683

Hey, you beat me on this....
Guess I should have done a previous search, too... since I'm getting old and forgetting what I had already posted...!

Mods/ admins: This is a typical case for two threads to be merged into one, I think.

Tks
G.

I think when I get home I am going to merge the two threads and modify the title slightly so people can more easily find this info in the future.

 

[Recovry4x4]

I got mine from the local Ace Hdwe. Guess I was lucky.