Cucvnut
Well-known member
- 3,804
- 61
- 48
- Location
- Carver, Oregon
Does anyone know what the factory exhaust size is of the pipe ? is it 2 1/4 or 2 1/2? I searched but I could not find what i was looking for.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
M1008 Exhaust size
- Thread starter Cucvnut
- Start date
Zinlu
Member
- 61
- 0
- 6
My truck is at my shop up the road. I'll check tomorrow and post back.
Cucvnut
Well-known member
- 3,804
- 61
- 48
- Location
- Carver, Oregon
Thanks!
DerangedMadman
New member
- 75
- 0
- 0
- Location
- Columbus, OH
I just measured mine and it is 2 1/4 th.
Cucvnut
Well-known member
- 3,804
- 61
- 48
- Location
- Carver, Oregon
Thank you sir !
axemurdock
New member
- 9
- 0
- 0
- Location
- ny
Would we get power putting on 3" pipes with no muffler ? Or does a diesel need backpressure like a gasser does .
ida34
Well-known member
- 4,120
- 33
- 48
- Location
- Dexter, MI
My muffler connections are 2 1/2" ID making the actual exhaust pipes 2 1/2 OD. The actual dimensions vary widely on a stock truck. The exhaust pipe necks down for about 6 inches right after the flange and it looks like it goes down to 2 1/4 but I have not measured. I am putting on new exhaust and started tonight and will finish in the morning so this is very fresh information.
Cucvnut
Well-known member
- 3,804
- 61
- 48
- Location
- Carver, Oregon
im just going to cut mine off and have turbo mufflers installed under the bed with turn downs
Zero_cool
Member
- 235
- 1
- 18
- Location
- Virginia,Minnesota
did you put the turbo mufflers on? how did they sound?
ALA2
New member
- 27
- 0
- 0
- Location
- lacrosse wi
I FOUND 3 IN flow masters used i think they sound good. turn downs under the bed not tight to fuel tank
Westech
CPL
- 6,104
- 208
- 63
- Location
- cow farts, Wisconsin
Stock exhaust is 2.5 inch from the engine to the inlet of the muffler and 2.25 after that.
same for a M1009
same for a M1009
jimmy-90
New member
- 344
- 4
- 0
- Location
- Haymarket Va.
That is what mine was. 2 1/2" from the exhaust manifolds to the mufflers and 2 1/4" the rest of the way back. I put a set of 2 1/2" dynomax straight throughs on mine with 2 1/2" pipes all the way back. Gotta say that pluming the pipe on the pass side was a real pain because of the e-brake bracketing. Latter on I wound up having to butcher the tail pipes in order to make room for a class-4 trailer hitch.
timarr
Member
- 364
- 1
- 18
- Location
- PT PLEASANT N.J./ MARTINSVILLE V.A.
As stated 2 1/2 to front of mufflers then 2 1/4 back. Just istall nice factory set from eastern military.