niferous
Member
- 715
- 6
- 18
- Location
- Houston, TX
Are these things one piece? Mine broke and I'm not sure if the threads are part of the padeye or if they thread into it. If it is a solid piece where do I get a replacement?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
M101A2 Padeye
- Thread starter niferous
- Start date
wreckerman893
Possum Connoisseur
- 15,629
- 2,054
- 113
- Location
- Akenback acres near Gadsden, AL
Pictures would be helpful....I have no idea what you are refering to.
niferous
Member
- 715
- 6
- 18
- Location
- Houston, TX
Sorry forgot to attach it and also to better describe it. It's been a hectic night. It's what is on the front of the trailer and the bolt passes through to secure the trailer and keeps it from dumping.
Attachments
KsM715
Well-known member
- 5,149
- 142
- 63
- Location
- St George Ks
I believe it is bolted on from the backside (bolt threads into it) I have the TM for that trailer let me see if I can find it.
Edit: Scratch that, according to the tm it has threads on the padeye and a nut holds it to the frame.
Edit: Scratch that, according to the tm it has threads on the padeye and a nut holds it to the frame.
Attachments
![padeye [800x600].jpg](/data/attachments/161/161422-e09cd37ebe3f48667c4995a9693e8518.jpg)
Last edited:
niferous
Member
- 715
- 6
- 18
- Location
- Houston, TX
So how do I get a replacement?
- 2,102
- 30
- 38
- Location
- Delta Junction, Alaska
Smack the flat sides a couple of times - that might loosen it some. Otherwise, as above, or make one.
niferous
Member
- 715
- 6
- 18
- Location
- Houston, TX
I had thought about that but now I may just go another route if someone doesn't have one they can do without.
jimbob1111
New member
- 66
- 2
- 0
- Location
- winder/georgia
Hi,
Two of my trailers have a pad eye welded back on. Grind everything down to clean metal, reassemble and weld it back on. I broke one putting it back on after drilling the hole a little bigger to make it easier to get the pin back in. The other one welded on is a previous military repair. I have no idea how long ago it was done, it's a M101A1 and it has been that way a LONG time & held up fine.
HMFG
Two of my trailers have a pad eye welded back on. Grind everything down to clean metal, reassemble and weld it back on. I broke one putting it back on after drilling the hole a little bigger to make it easier to get the pin back in. The other one welded on is a previous military repair. I have no idea how long ago it was done, it's a M101A1 and it has been that way a LONG time & held up fine.
HMFG