Where can I locate one of these trailer hubs?

[Lonesome715]

I know a lot of thee trailers are getting cut up and used as beds on bobbed deuces. So I am hoping someone has the hubs lefts over. I only need on side and if the bearings are still good I will take them as well. I also need the hub nuts and washers from both sides. I am trying to get this done for someone so this is a time sensitive issue. If you have the parts I need please let me know what you want plus the cost of shipping.

The trailer is a M116A8 but I think it is the same as a M101A1.

 

[NDT]

These are Dexter axle parts available from trailer supply houses. Place here had the bearings in a bushel basket.

 

[Lonesome715]

Fleet pride here has the bearings and can get me the hub, but the cost is way too high. That is why I am hoping to find a good used hub. Even if I have to buy the internals new.

 

[papercu]

I think most of the trailers bodies being used for the bobbed trucks are M105?
Seems as if Kenny was swapping out axles on some trailers he just bought but he and a lot of the other folks are on the road going to or at the rally. Wayne

 

[Lonesome715]

It figures. I wish I had asked this question a couple of weeks ago. Then some one going to the Rally could have brought one down. I have seen a few bobbed deuces with this type of trailer body.

 

[Lonesome715]

Can any one help me locate one of these hubs?

 

[ida34]

You want the hub for an M101A3 or A2. The A1 and straight M101 had a M37 bolt pattern.

 

[Lonesome715]

That is one thing I was confused on. Thanks for the clarification.

 

[96XJ9705]

That is one thing I was confused on. Thanks for the clarification.

Do you still need these hubs?

 

[Westech]

almost two years later?

 

[Lonesome715]

I got the hub I needed already. As a matter of fact I was in the parts store today trying to get new bearings for one of them.

 

[96XJ9705]

I got the hub I needed already. As a matter of fact I was in the parts store today trying to get new bearings for one of them.

Ok, came across this thread while looking for a hub part number to use to replace my hubs with 5x4.5's.

 

[Lonesome715]

That I have no idea about. I found this hub at Delk's.

 

[96XJ9705]

No worries. I may end up replacing the whole axle anyways just to drop some of the weight.

 

[Lonesome715]

I wish you were closer, I would love to get it if you replace it.

 

[96XJ9705]

Yeah, it looks like a replacement is needed. I'm not sure what I'm going to do with the old one. Best I can figure it is a 5000lb axle and I don't know of many needs for a 5000lb axle with 43.5" spring perches.

 

[Lonesome715]

I know a shipper that runs out there. Maybe he will bring it back for me. How much do you want?

 

[96XJ9705]

25.00 for hubs, brakes, axle, and ubolts too much? I'm thinking I'll keep the shocks and bump stops for the new axle.

 

[Lonesome715]

Shoot me your zip code and I will ask my shipper when he will be out there again.

 

[Harleyflhp]

Where can I get a hub for a M101A3?