• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Search results

  1. Bill Nutting

    M151 carburetor rebuild - Brooks Engine service

    The number I have for Brooks is 727-871-4283. I sure hope they are still around. I had them rebuild the carb on our M151a2 and the thing runs like a top. No flat spot, no running with the choke out a 1/4 inch. Whatever they do to these carbs, works. Some of my friends have had the same results…
  2. Bill Nutting

    M923 NHC250 stalls when stopping. Idle seems low too.

    Hey Simp, I lIke your avitar!
  3. Bill Nutting

    Charge / Tend HMMWV via slave port

    Good advise to check the 12 volt batteries first. Get them up to charge. Then you can use a 24 volt Battery Tender. You can install the tender on the truck and connect to the 24 volt battery posts. Route the power cable somewhere with easy access. No need to disconnect the tender from the...
  4. Bill Nutting

    M923 NHC250 stalls when stopping. Idle seems low too.

    Because the fuel is being sucked from the tank, finding air leaks can be hard. Mine was loosing prime and it made it hard to start. I installed a 24volt electric fuel pump at the tank so I was pushing the fuel up to the engines fuel pump. After running at an idle for a few minutes, we spotted...
  5. Bill Nutting

    Where did all the big trucks go?

    We have been working with our state government for a few years in Michigan. The Secretary of State and the last two governors sited the same lame excuses to keep HMMWV’s off the road and block legal registration. Let me blow holes in their misguided “logic”. 1) They don’t meet federal vehicle...
  6. Bill Nutting

    Where did all the big trucks go?

    Well this makes some sense. Perhaps the reason for the “no sale after use” clause had something to do with a license agreement with GM so the sale of military HMMWV’s didn’t interfere with the sale of civilian Hummers. I still don’t know what the arrangement was between AM an GM for the Hummers...
  7. Bill Nutting

    Wait Light Issue

    First off, welcome the site. I only have one Diesel truck and it doesn’t have glow plugs so I won’t be much help to you. Do you have the Technical Manuals (TM’s) yet? If not, go to forums above, scroll down to “Present Conflict Vehicles” in this forum you will find the TM’s for your vehicle...
  8. Bill Nutting

    Where did all the big trucks go?

    Please say it isn’t so! Why in the world would AM General do something that took their vehicles off the roads? Lawyers no doubt. AM was probably afraid of law suits if someone got hurt in a crash...
  9. Bill Nutting

    New guy from NC with M1028

    Welcome to this site and the hobby. It’s really nice that you and your dad can do this together. You are building more than a truck... Enjoy every minute! Be sure to check in here as you progress. We all like to see these projects. If you have any questions about that truck, you will find...
  10. Bill Nutting

    Where did all the big trucks go?

    I’m going to be there with my 5 ton. I will be a member of the MVPA convoy. I have done some extensive modifications to my 934, so it might be disqualified. For the most part the exterior still look stock but the interior is not. On the other hand, if I am the only 5 ton entered, I might have a...
  11. Bill Nutting

    1954 M37

    I’m glad to see it went to a good home. You did good Mullaney!
  12. Bill Nutting

    lsmft

    Through a cot with a lounge chair pad in the back. Some mosquito net might be good to have. Enjoy the adventure!
  13. Bill Nutting

    7 Pin Trailer Wiring Connector - No Reverse Lights?

    I wired backup lights on my flatbed trailer. I use the center pin on the 7 pin trailer cable. For lights I use two small fog lights mounted under the deck. It is helpful backing up at night. I am not aware of a connection in the military vehicle trailer connector for a backup light. I don’t...
  14. Bill Nutting

    Texan New to SteelSoldiers

    Welcome from Michigan. This is a good place to hang out with good folks...
  15. Bill Nutting

    Howdy from South Carolina

    As long as it checks out mechanically, I would just drive it home. Have a chase vehicle and a few good friends go with you. I promise you will never forget the adventure! I brought my M934 home in January. Cold as all get out, drove it off the lot on 8 year old fuel. We were 1,000 miles from...
  16. Bill Nutting

    M1088 camper conversion

    Hey TJ4man, Welcome to the site... When I saw your avitar I thought you stole mine. :) Turns out we just have the same truck. I converted mine to a motor home. I took a couple years working on it after work and on week ends. It continues to be a work in progress but I am able to live in it. In...
  17. Bill Nutting

    just took in a m101a1

    I built this trailer to be light. It basically was designed to replace sleeping in shelter halves. The idea was to have something dry, off the ground and bug proof. The walls were 1/4” plywood framed with 1 X 2. The windows were vinyl basement windows. These gave us good ventilation and screens...
  18. Bill Nutting

    What have you done to your 5 ton this week?

    What paint did you use?
  19. Bill Nutting

    2.5 or 5 ton 6x6 In SE Michigan?

    Yes, get the cab card and don’t forget to not smile while driving on a Michigan road. Governor Witless has outlawed smiling on Michigan roads... ;)
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks