Search results

Detroit locker are a great upgrade

Simp5782 is on the ball.

Need a m1084 transported from Tennessee to Pickens SC. Anyone got a space on their trailer?

I heard govplanet lost their contract? Who is going to do GSA then?

Hooah, I had a mep804 , several mep803 and mep831 before, but ill crank for an extra few seconds next time.

Yes , I am starting the generator as per -10. Never seen it run without issue. It was used paralell before and was reset in 2011 and has 500 hours since. I replaced the mosfed im the voltage regulator and it looks pretty normal. What does this little square potentiometer in the right lower...

When I start the generator i most of the times get an under voltage light . When resetting, it shows over voltage and shuts down. The Gauge shows 174v on all three phases at 60 hz. Sometimes the generator gors straight to the over voltage light and shuts down. The voltage adjust has no impact...

...

Has anyone here attempted and graduated in here by rebuilding the alison transmission. Did you document your progress?

I'll check the wires tomorrow, thank you for that link Guy. Will also check the other parts

Yes, Guy my A1 is made by TRC and i replaced the mosfets with new ones, but same results. I will check out that voltage reostat again.

It was in a parallel mode once. Got anything on your mind , I ahould look for?

Hmmmm I didn't notice a locking action. Are you supposed to pull on it to lock?

That fact makes sense to me as well, I like to just double check it from the RPM i should be seeing

My voltage knob differs from the part number in the tm 9-6115-643-24 There it calls for a RV4NAYSD203A mine is however RV4LAYSD203A. Does that matter? Because the results I get differ from the results I should see as per TM

Voltage knob does nothing. Im reading voltage from gauge and multimeter 170v output at 60hz . I dont know how much rpm, but I would like to check it

The generator puts out electricity at 60hz but 170v to the L's and neutral. Can someone give some advice on how to manage the voltage down to 120v?

The # amp fuse I replaced the old one with didn't blow. I see a different oddity : the gen set has under voltage light on. The AC switch doesn't close, stays open. I got my environment unit connected to the 3 phases. I have to turn on the battle switch and then close the AC connect switch and...

Hello all. I am having a few issues with my gen set. When I start the gen, I will get a 'under voltage ' light. Someone has messed with the k5 relay before, it was not bolted to the base and loosely in there. They may have replaced it or put a faulty one in. I cheched the magnetic sensor on...

To all the m123 owners. Do you have any pointers as to what to look out for ? What do you use yours for? Would you buy it again?