Search results

anyone seen the cross reference for light bulbs for napa i had the page from a website but i cant seem to find it any help would be greatly appreciated thanks dustin

Its not to hard to do id make a cardboard template of the cowl cut the peiceyou need try to form it to your old cowl then go from there use a small grinder with a thin cut off wheel and just take it one step at a time

sry ment heat the flange not the tie rod stud dont forget heat expands so if you heat the stud it will just lock up

i always leave the nut on and if after a couple wacks it dosnot pop put a little heat to it

ha thats great:razz:

yea thats pretty much what it comes down to

Looks good only thing i might do to it would be to x brace the arms going up at an angle / towards the front axle sorry i cant word things that well im exhausted :roll:

im just saying, they were made for bolth road and off and when it comes to off road weather your going through the jungle or the desert hills without a locker whey really need to be limited slip or a locker , not like i was saying they are junk....... i love my truck dont get me wrong i bought...

these trucks should of came with some sort of locker , a 6x6 truck is useless if it cant get through most of the stuff a jeep could the reason i say is because my truck is going to be used for off road recovery and i can totally see this happening lucky enough i have a winch and a crane to get...

where can you purchase overhaul kits or gasket kits for a realistic price any good sources 69 herc multi fuel n/t

middleboro auto salvage has a reo and two multi fuel trucks its in mass

i took apart my switch and all the pieces fell out on the bench so gathered everything back up and found a thin piece of spring steel snapped in two but have no idea where it would go does anyone have an exploded view of the switch or know by experience where this part goes thanks

bunker of doom.com has a schematic that worked great for me

checked the harness looks good so i took apart the tight switch and i noticed a thin piece of metal that was in there was broke in two i cant figure out where it went or came from any ideas ?

got to go to work but i will throw out some ideas tonight or tomorrow and see what ya all think

:idea: :!: :?: :grin: ive been thinking about fabing up a powersteering kit for the m35, or just the brackets for it and the buyers could buy the piston or air can and lines to save money i know it could be done for hundreds less than what all those companies are charging i would like to...

just finishing up hooking up my lights using a schematic from bunker of doom pretty good one if you need a harness schematic , but anyways i hooked up my lights all good but when i hit the high beam switch it pops the fuse/breaker so i unpluged all the lights try again and low beam or high beam...

same happened to my bracket all twisted junk im going to make up a top and rear out of 3/8 flat bar might sell some seen a few guys with the same problem

do you know if these frames are the same as the m35 ? thanks dustin

oh sorry forgot to mention its a non turbo engine