Search results

bump

no issue here, my pics always post right side up????????

My 44 GPW

These axles are quite simular to the M135 / M211 series axles. Can the internals of the newer ones (27 spline) be swapped into the housing of the WWII ones (10 spline) ? or, Are the housings the same? Reason, broken G506 rear end & the M135 / M211 axles are easy to come by

Yes!

a few campaign photo's

USAF Ambulance 78B3020 '78 Dodge W400 5.9l gasser, auto trans, full time 4x4, D60 front/D70 rear 4.88 gears, Detroit locker in rear. Not an M886

Area Lodging Info @ www.oscoda.com/lodging Show location is above the river & below Van Ettan lake

I am honored to coordinate the Military Vehicle participation with the American Veterans Traveling Tribute, sponsored by the Wurtsmith Air Museum & the Oscoda Legion Riders. This incredible event will start on Wednesday July 22nd @ 1500 hrs with the escort of the AVTT truck & trailer from...

1978 USAF field ambulance w/winch Dodge W400 4.88 gears w/locker in back.

That carb is a GM quadrajet. unless the heads have been replaced that carb & intake aren't adding any power

Don't really know the key code, but they are all the same.

Don't have a M37 to measure. Data tag shows 53" from center of front axle to the center of gravity which looks close to the back of the cab (viewing the data plate) anyway, I'm thinking of transplanting a body & that measurement is needed to see if this will work.

'84 M1009 60k on the clock Apologize in advance if there's an easy to find thread on this issue, I searched, because I know it must have been covered here. On cold starts, this things is scary loud clanking. Quiets down after the fast idle(<-- wrong terminology) kicks off. Once warm it runs...

$7500 tops with the "excluded" stuff Restored? Hardly. Paint & interior redone is what I saw.

The M880 is the same as a civi 3/4 ton. That being said a dressed & lubed 6bt can go about 1100lbs where the stock 318 comes in about 700 lbs. So we are looking at 400 maybe 500 extra pounds depending on trans choice. The D44-8F is rated @ 3500 lbs. The plow & bumper hanging off the front of my...

The only flush systems I've seen do not use pressure, other than the transmissions pump. The trans cooler lines get connected to it and as the old fluid pumps in, it pushes the new fluid into the return line, once clean fluid is observed pumping out, you shut off the car & reconnect the lines...

Change the fluid & filter. If it starts to slip it's because it needed to be rebuilt. You didn't drive it with "its barely showing on the dipstick." running them low on fluid is a real quick path to a rebuild.