Search results

I have what I assume to be a bad cold start board on my 85 m1010 6.2 can anyone help with manual glow plug control conversion thank you in advance

Thanks for the info

My m1010 is leaking fuel from behind the filter replaced the housing and the filter. leak stopped for about 6 hours now as bad or worse than before change. had to reuse switch fuel heater and filter sensor .heater is broke but not leaking I think it may be the pressure switch any clue where I...

Hi I need some information please. fuel injector return hoses are rotting off .l can't find out what type of rubber line to use and what size. called all local auto parts and diesel repair shops nobody can help .hope someone here can thanks in advance.

I only have low speed how do I test to see if switch is working

I would like to thank everyone for the help diagnosing my problem . it was the a/c relay. thanks again. I am sure I will have more questions about the truck in the future.

thanks for the info I will look tomorrow

thanks for the help so far all switches are off when I connect batteries the a/c clutch engages with key off does anyone know the location of the a/c relay I think that is stuck on thanks again

I will check inside the box after battery is back in the truck thanks

checked battery voltage this morning only front battery dead 1.2 volts rear battery12.1 volts so is it the 12 volt side drawing power?

switch is on. they have been load tested both under year old checked out fine. rear spotlights don't work and front blackout light in grill is missing. wondering if that could be a problem?

alternators charging runs fine 24 volt 200 amp shut it down and leave it dead batteries in 24 hours