Search results

Thanks I am expecting a few speed bumps taking the top off. The hatch folds back and has two legs. (Have included a couple of fotos) Generally the HMMWV is stored in the garage. You are spot on, once I get the top seal in place, I plan on trying to mitigate water ingress (hahaha) at the...

Apologies for the confusion. I own a M1025 that is outfitted with a turret. I have removed everything above the hatch cover so it can fit in the garage. I want to lift the hard top high enough to insert a new seal above the windshield. I am not aware of what seal (if any) is at the rear of the...

Would like to know the weight of the M1025 slantback hardtop with all the turret components removed and with the turret kit intact after disconnecting the main members. Thanks

Thanks for the reply!!!

I have seen so many different types of neoprene, please advise which type and where the proper neoprene can be procured. Thanks all!!

Thanks for the advice!! I am ordering the cargo shell hatch [ SEAL ] today. Out of curiosity, is the neoprene 4 inch wide, and peel / paste or I need to also use butyl tape as well?? I still have the turret so will need to go with the PS 699-10-14 approach. I have included the PS as an...

Did you rivet the 1/16 neoprene after installing the butyl tape?

I messed up!! I should have asked which vehicle you had!! I have a HMMWV M1025 A0 thus the reason the reason the change out did not work. Next time, I will ask the vehicle question!! THANKS FOR THE ASSISTANCE AND MY APOLOGIES for bugging you!! Thanks again!!

I have attached a cut & paste from the TM to see if we are discussing the same;

Just for confirmation, you only removed the splined shaft and not the entire assembly (attached)

I applied the save all "WD 40" but will apply penetrant now.

Sorry, I meant to say, Ajax MD.

RUSS, I bought all the kit and removed the military wipers. However, I am struggling to remove the existing wiper fitting. Do I need a small gear puller to remove so I can use the new adapter? Have attached fotos of driver and passenger attachment points with existing kit installed.

thanks!!

Nice way to distribute the loads. Out of curiosity, what thickness is / are the plate(s)? Did you use steel or high strength aluminum?? Thanks in advance.

2 can or 4 can?? I am not sure how to PM??!!

I like the set up. BTW, i cannot see the bolt pattern on the 2 inch receiver. Is the receiver welded to the reinforcement plate -or- how is it secured?? Thanks

Thanks. This good news as the prop is a pain!! Great Job

I noticed that you have the hood prop mounting but no hood prop. Did you remove since the two (02) gas struts / springs will safety keep the hood from falling??

01. Finally got my M1025 registered in Reno so will be looking out for places to go. I have been traveling on some back roads near Boca Lake, CA. 02. I would like to participate but presently working overseas. 03. Not a problem, if I am in town. 04. M1025 4 door, slant back. Flat black color.