• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Search results

  1. fasttruck

    Wooden floor in M37

    Various parts houses catering to those who restore old picvk-ups sell the metal strips that hold the wood down in both plain and stainless steel.
  2. fasttruck

    Tobyhanna Army Depot, PA

    The last time I went to TOAD, also to pick up shelters, Follow msigns from X2 on I380 to Pa611 to main gate. Interact with the friendly guards there. Get pass, proceed 500' or so ands turn left to a second gate. See guard in there. Pass through this gate, go to top of hill, turn left and site is...
  3. fasttruck

    which are the most used heavy duty wrench sockets on older 5-tons

    Don't forget 1.5" and 13/16 square for doing those bud wheel lug nuts.
  4. fasttruck

    M35A2 Cargo, Dirt, Top Soil capacities?

    TM 9-2320-260-10 for among other things the M817 has a table in it that tells you how much a cubic yard of various potential dump truck load materials weights. Run the numbers and you will know how much to put in your vehicle.
  5. fasttruck

    This Was Donated to Our VFD

    Reference post 9: start calculator before before typing. Aforementioned 150gal of water weighs about 1200 pounds which ought to make you overweight: post 7.
  6. fasttruck

    This Was Donated to Our VFD

    150gal of water weighs about 600# plus the weight of the tank and any tools or hose carried. Will you be overweight ?
  7. fasttruck

    Winching the SEE

    If you have .5" cable a 6" sheaved block should be required. Most rigging texts give the cable to block ratio as 12:1. Too small a sheave will strain the cable when it is under load or break the sheave. Don't ask why I know this.
  8. fasttruck

    "Rescued" M816 Wrecker

    Reference the crane not operating: There is what the Army calls an "angle drive" similar to a u joint in the drive shaft between the power divider and the pump which will seize and fail from lack of use. Think they would have put the pump right on the PTO and eliminate all that brick a brack ? I...
  9. fasttruck

    "Rescued" M816 Wrecker

    Reference the crane not operating: The drive shaft from the power divider to the pump includes what the Army calls an "angle drive" in the shaft which seizes with lack of use. I Got one from Memphis Equipment nd as I remember it was not excessively expensive. Check -20P for description and part...
  10. fasttruck

    Request M35A2 Retrieval info

    A M185 is a M109 with different wiring in ghe box, possibly to remotely operate a generator. Chassis is same as M109 and M35.
  11. fasttruck

    need 150 mile tow Los Angeles to Ridgecrest, Ca. M932A2

    If you tow it put the pins in the rear brakes and the t case in neutral. Check towing instructions in -10 manual. Or if you have an army truck or a civi wrecker with rear air connections hook up the air lines and will brake like a trailer.
  12. fasttruck

    Deuce driving tips

    Don't ride the clutch or lug the engine. If you are going less than 40 mph you shouldn't be in high gear. Do get and read and understand the -10 and -20 manuals for this vehicle. Do get up close and personal with the tire gauge and the grease gun. The grease gun is your friend. Grease is cheap...
  13. fasttruck

    WI to NY transport needed - HMMWV

    the cash rate for a port authority facility in New York fort a 5 axle truck is $105.00 for the round trip and an additional $43.00 or so each way on the triboro facility of your choice to get in to Queens. The politicians will try to toll any structure bigger than a culvert. The last time I...
  14. fasttruck

    m35a2 ny to ma.

    What kind of truck is it ? Runner ? location in NJ
  15. fasttruck

    New guy with a new ride seeking winch purchase advise

    If your m817 was built without a winch, the single side drive pto may well face the rear of the truck where the hoist pump for the dump was. Winch built m817 had a very hard to find and expensive to buy double faced pto which ran the winch off the front and the hoist off the rear. Other m809s...
  16. fasttruck

    Tractor - Nebraska to Washington

    If you can get the width down to less than 102" this will make the project easier and more attractive to the truckers. Over 102" and permits are required and restrictions on routes and travel appear which will dramatically increase the cost. No night travel, etc. How many states are involved ...
  17. fasttruck

    M819 wrecker questions?

    These vehicles were designed to tow the M260 aviation flatbed gooseneck trailer. They will also handle a M 172 or similar trailer with a gooseneck. They cannot be coupled to a platform trailer such as a M127 or M821 as the corners of the trailer will hit the structure of the tractor when...
  18. fasttruck

    M870A1 Acquisition Thread

    In an earlier life I used to deploy the m870 trailer with a M123 ten ton alone all the time. My tractor's winch would run without your hand on the air valve that controlled the movement of the captstan so you used the transfer lever to start and stop tohe truck while the winch ran. Pay out 3-4...
  19. fasttruck

    Upgrading a M923A2 for Fire Department Usage

    Remember 900 gallons of water weighs 7470 pounds which gets you close to the cross country weight rating of the vehicle. 5tons also have a high center of gravity. I believe NFPA re[ported a leading cause of apparatus related fatalities involve tanker rollovers. Putting a pump, hose, tools etc on...
  20. fasttruck

    M35A2C from Just south of Tampa FL to Saint Paul MN

    Driving any MV without a heater to St. Paul in winter will be a character building experience.
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks