Search results

I definitely got genuine own plugs from Macmotors. But I’ll do some testing to see what I got going on.

Thank you. I’ll check them.

So lately the temperature has been dropping into the 20’s at night and 40’s during the day. So the truck sits a few days typically before I start it. On start up it fires right up but blows white smoke that smells like diesel. When I say it smokes it fills my front yard with smoke. It runs a...

My truck is still loud haha but definitely a lot less. Keeps the kids quiet in the back or at least I can’t hear them. Without taking the body off the frame there is only so much you can do.

There are a few places that I found that need to bed sealed up with seam sealer. I’ll take a picture of where. It’s kinda hidden

Never carpeted anything and it came out pretty good. Also if you go this route get a sharp pare of scissors.

So the carpet is called underfelt. It’s also called 4 way stretch. It is not to bad to work with. They use it a lot in camper van stuff. It is glued down. I used 3m spray glue. Spray the surface then spray the carpet and stick them together...

So drainage I just covered it up. It’s water tight from the rain. I used a lot of seam sealer. I have the PlanB top and doors.

These are a few pictures from when I was putting it all together.

Also for the tunnel I used 3/4 plywood wrapped it and glued down the 4 way stretch carpet. The hole piece is held down with bolts into nutserts and the top of the bolt is capped off to give it a nice finish.

Used some sound deadening stuff off Amazon...

Maybe injectors? I have been putting additives into the fuel to clean up the injectors. Not sure if that helps. Could be a simple cheap thing to try.

And if that all dosnt work you might need some resistors. Got some off Amazon for cheap. But I don’t believe I needed them in my application due to being sold some faulty front blinker/lights.

The cannon plug to the flasher has ABC on it. A is flasher output(+), B is flasher input(+), and C is ground. If you try the bulb thing and that dosnt work this is how you hook up the flasher unit.

Also did you change the little bulb in the blinker handle yet? If not first try taking the bulb completely out and see what you get. If no change or nothing works get the LED bulb. ***** I would try this before the flasher unit****

What is your current flasher unit you have now? Also what brand lights do you have, if known. Sometimes they are unbranded and made in China. The only reason I ask is that someone else had put together what brands work with what flasher units. The cheapest way to rule out in my experience is to...

I can get the light to flash/blink. Blink then back to no light blink then back to no light.…I’m guessing there might be an issue with it being on/running lights then needing to get brighter when the blinker is switched on. Also noticed some other blinkers units out there appear to have...

I did the same thing. Got a 3 wire no load flasher. Still didn’t work. Update—— So I contacted the seller of these lights they told me that they were discounted because they were defective somehow and to pound sand. Even tho the listing stated New and mentioned nothing about the defect. Anyways...

Yes I found that and bought a led flasher and hooked it up to make sure it was going to fix my problem but it didn’t.

I have the ones that give a layout of everything with the wires. But wasn’t sure if there is anything that gives the direction of flow.