Search results

Quarkz has led in the front. See what type of flasher box you have, mechanical or solid state. If it's mechanical it's probably toast, I updated to the solid state. The conversion instructions are in the -20 TM. I rebuilt all my lights, Saturn Surplus had all the parts.

As much as I wanted to use the original batteries I just did not have the $400+ to shell out for 6tl's so I used a pair of surplus UPS batteries I had. I set them on the original tray and held them in place with a rubber bungee. I have the original hold down parts, some day I will put the...

I never left CONUS, Dave was a middle man for me to bridge the gap of the Atlantic.

CUCV on the left, different(shorter over wheel well) lengths, uses pin/clip to attach. On right M880 uses stud/nut to attach.

Dave came to the rescue for me when I needed some help from the UK. His attention to detail and timeliness was amazing, could not ask for a better friend, thanks Dave:grin:.

The brackets that attach the troop seats to the bed are different, I can post pictures later and show them. May be other differences though I am not sure.

Good job, looks like they "civilized" the ignition system, and that spin on filter conversion, first time I have ever seen one on a mil jeep.

The seal is cheap, however it is somewhat labor intensive. You would have to disconnect and slide the transmission back far enough to get the torque convertor out to replace the seal. Doing this by myself I would figure a day of work, a shop set up to do it 4-5 hours perhaps. I would think...

Tom mine looks the same, make sure when you put the cover on that the bottom of that shaft goes in the "fork" in the bottom of the governor.

Saturn Surplus, Red River Parts(must have part numbers ready or no go), Arts Parts, SS member popacom has a warehouse full, currently moving them to a new location, TNJ Murray, probably others I'm forgetting. The group has had no luck finding cargo covers.

Just be glad it happened with the engine out. You can get the solenoid for $30 shipped so don't let the shop rip you off on one if you need it.

Welcome to the I want a cargo cover club and good luck, post up some pictures of your rig, welcome aboard.

The air lines pressurize the brake drum to keep water out. The air tank should be drained regularly. Each air line is identical to it's parent brake line, don't get them mixed up!

PM sent.

Which one ?

Speaking of transformations, before and after... Please vote for my goat. :lol:

That is the factory throttle rod/linkage. I had to bend mine in a couple of different places to make it operate freely. That is a air pump that atomizes diesel into the air box for the cold start.

Body plug gasket http://www.skygeek.com/mil-std-ms35769-92-o-ring.html

These seem to be the correct size but it's a 25 minimum order, they also have the body plug gaskets. http://www.skygeek.com/mil-std-ms35769-31-o-ring.html

Carrier Cover 2540-00-880-4018 Cab 2540-00-880-3997 Wiper arm new 2540-01-043-5380 old 2540-00-081-9518 V belt water pump matched set 3030-00-833-1298 Front and rear brake rubber lines 4720-00-410-9787 Center rubber lines 4720-00-080-6516 2ea 4720-00-781-7838 1ea Tractor/carrier interconnect...