Search results

Man i lived off of rip its!!!! The orange flavor was the shiot. Nicotine and rip its kept me going for days on end!

That is possible. The units they were ordered for are very large stationary mixing machines they used 4 in a series for each fluid coolant hydro and oil. The machines have since been changed over to much more sophisticated design of centerfuge and MASSIVE spin ons. So they had dozens of these...

On the alison 1000 it takes a valve body change to get the 6 speed. The rumor used to be it was all in the programing. But it takes a vb change and reflash the tcm. as for the 500 series trans or 2000-4000 series im not sure about. I would assume vb replacement or mods are a must to utilize...

Id gama the **** outta some goats with those.

Use a valve on it you dont.

Just the filter that was layin around. While i have ran them short term in my truck i run a different donaldson number. Im not following on the thread base issue. There is several different media type filters for this base. Machines at work use this base with a much larger filter (length) some...

Deleted. Duplicate post

Man that is sharp.

Hey fellas not a humvee owner but after working on deuces and 5 tons for years here at the house (im by no means a professional mechanic) but it doesnt matter how many times i flush these trucks it is always bad. I have run a coolant filter now for about 150 hours on my personal 925a1 and im...

Roger that thanks Wes. Im kinda layed up with this knee trying to pick a way at things i can reach from ground level. I ended up watching some of your vids again. With the way im fighting this a/c "kit" install im starting to think your route would have been easier. But maybe things will start...

You be the man.... man...

Sorry i guess it would help a ton to know what alt im using. Its a modern delco unit. So i need the big wores marked 5 and neg and then the 568. Is what im guessing.

Trying to work on the 923 alt conversion but my laptop is dead with the tm's on it. So i need bailed out here fellas. I have 4 wires off the old generator 566 568 5 NEG. If I remember correctly i just need the neg to negative of course and 5 to positive. 566 i think is starter protection and i...

I had some stall mats layin around but my hinge was ready broke so i went the route of lifting the seat 5/8"

First off is the condensor hiding behind the grill. and the other is my solution to seeing the arcing under my seat from the big 8d bats.

Well that answeres that. Ummmm.... where would one haplen to find level III ballistic glass?

You are correct the nipples are jic swivels. And the brass is npt. While i would NEVER recommend them being used together under high pressures. they will be more than fine under the pressures a coolant system sees. Thread sealant is key on the joint, but the jic flare end buts perfectly against...

I had knee surgery yesterday to remove some pieces of bone that had chipped off my joint so im layed up for a couple days. But the a/c install should be done this weekend. Also if you guys havent filtered your coolant yet donyourself a favor and built a kit to do so. I never get over how bad...

Vet day parade last saturday. Rolling thunder topeka chapter had some of their sweet rides out there too as usual the heater core swap i did last spring has helped my heat a ton. Pops and i were more than warm in that cab. The female vets in the back im sure were beyond cold but they sure...

Looks fantastic sir! You may have covered this already so i apologize. What are you doing on windows? I watch the local skating rinks up around my uncles house in MI. They change their lexan out quite a bit. Its 3/4" and from my testing stops a 45 at 25yards. I have not tried faster rifle...