Search results

Hi OK, I adjusted the screw on the voltage regulator and it made no difference in the voltage. I have 24 volts going to the regulator and I am reading 24 volts on the alternator. Could you tell me what the small ring terminal wire on the alternator is for and if it should have any voltage...

Hi Gentlemen, I made a mistake in the title. I replaced the voltage regulator not the alternator. I have a 60 amp unit. I will check out the 5a wire. Also I did not adjust the screw. Is this to adjust the voltage output? Ken

HI Replaced the voltage regulator and brushes but still in the yellow. Measured voltage at the voltage regulator with her running and measured 24 volts. Question? Am I reading just the battery voltage at this point? Is there a way I can measure just the alternator output? Other ideas? Ken

Hi I have added a regular trailer hitch to my Humvee . I have it wired right now for 24 v but want to change it to 12v . Not sure what would be the best way. Need ideas. Ken

Hi Thanks for the P/N but I still can't find a source. Ken

Need help where to buy brush set for my alternator. Ken

Hi I think your right. I have ordered a new voltage regulator. Will see if that takes care of it. Thanks all for the help. Ken

Hi everyone I haven't had time to do all of your ideas witch I will be doing. I did drive into town today, about 25 miles and the gage went into the green for about 20 minutes. But when I stopped and started again it was back into the yellow and stayed there all the way home. When I got home, I...

Hi My Humvee is a 1991. The generator is a 60 amp , 28 volt Prestolite AMA5104UT. Ken

Hi Ok, with the batteries charged up and the engine running, my volt gage runs in the middle of the yellow. I added leads across the gage, and it is reading around 22 volts. As I drive her the gage will run down to the bottom of the yellow and still read about 22 volts. Is there a way I can...

Hi Thanks for the help guys. Ken

Hi What would be the best brand of glow plugs for the Humvee? Ken

Thanks for the help. Ken

Hi 1991 M998. Ken

Hi Where can I find info on where the placement of stickers and data plates ? Thanks Ken

In regards to using a frost plug heater, I tried three of them from Kat's. The first lasted about a year and a half, The second about four months and the last about three weeks. I made sure the element was not touching the block on the inside and it was never on more than a couple hours. I...

Action It is a Kat's 1500 watt tank heater for the cooling system P/N 13150. Ken

Action Yes it is a block tank heater.

Hi Can you tell me the location of the coolant drain plug on my 91, 6.2 . I'm going hook up a tank heater. Thanks Ken

Hi What would be OEM glow plugs. Ken