Search results

Hello All, I have read all of the threads about B4Thunders apecs 4500 controller from years ago. I would like to try this setup. Does anyone have the programming parameters? I can get the controller, the programming interface cables and the software. I just need the specs. Thanks ahead of...

Like your use of old hardware as sinkers.

Lol. I can’t run, can barely take a knee, but I keep turning wrenches and I keep teaching Army JROTC.

I understand back work (2019). Just did both knees in June.

CUCVRUS, glad you are OK. Take care sir.

1 Pariot of many, all ok?

Figure 37 lists all of the internal components. Get part numbers there, then look in section at the back of the TM to find the NSN listings for figure 37 by part number.

I found the info you are looking for. In TM 9-2320-289-34P, fig 33 item number 8. On the far right QTY 2 Next picture is from the back of the same manual to get the NSN FIG 33 item number 8 I hope this helps.

I hope this helps. https://www.oreillyauto.com/shop/b/cv--driveshaft---axle/axle-u-bolt-kit/9686a16d9eeb/v/a/3456/automotive-truck-1986-chevrolet-k30-pickup-4wd?

Black permatex

Magnets or 100mph tape

Every cucv upon starting requires a blip of the throttle to get above idle speed to get the rpms of the alts high enough to start generating power. From the -10 manual Item b. 4

That is how they work, always have. I do not know why. Worked the very same way when I drove them on active duty in the 80s.

I drove an M1008 through desert storm in 91. We had hummers but the unit we got attached to took half of them and gave us the 1008s. Im 2006 TDY from Ft. Riley to Ft. Sill my unit was running training for convoy driving to other services and I pulled a fully equipped M1031 out of DRMO so I...

Thank you for the input and the pictures. I am convinced I should do this now.

Thanks for the reply. I appreciate the help.

I have been researching a cooling system upgrade by paradox by design. Has anyone here used it? Would you recommend it? My M1031 only has 16 k miles and I want to make it last as long as I can. Thanks for any feedback! Dean

Today was a hardware cleaning day. Seemingly endless stream of ziploc bags of nuts and bolts to be cleaned before reassembly begins. before and afters You get the idea… lots more, no need for more pictures.

I do not know of anyone on the site that sells them. Internet search shows them on ebay and amazon.

I have seen no cracks in anything. It all looks like a newly assembled engine.