Search results

I'm still leaning on the P6 plug being the issue, but i'm not sure on what steps to take should I try to take it apart? How difficult is that? I can't seem to find this piece of the harness in the TM, I see the plug but I'm not sure what components it all comes with, has anyone rebuilt one of...

I've done this several times already, nothing appears damaged from what I can see, but the CB1 is still tripping when I engage the power

So to give an update on whats been going on the last few hours, I d/c the J6/P6 inspected the pins and did notice a bit of corrosion like I said but not a significant amount, I cleaned the pins and reconnected it and as soon as I turned on the power CB1 tripped, okay thats something, so I d/c...

CR-1 diode (I don't know which one is terminal 1) left terminal to J6-33 OK , right terminal nothing S10 terminal 2 to P6-33 okay There was a slight bit of corrosion on pin 33 of J6 but it didn't seem like a significant amount to be causing the issue I currently have, there wasn't alot of...

You were right, I was checking the wrong one, I apologize for that CR1 diode has 23.5Vs on both leads with no changes in off/prime & run and start I'll inspect J6/P6 and post my findings

CR1 diode: 0 volts on both leads in off/prime & run AND start

Good morning guys, MT4 Shunt both big terminals: 23.5Vs with S1 in off, 23.5Vs in prime/run and start

Yes they are fully charged and I load tested them several days ago, no the panel lights do not come on

S10 terminal 2 dropped from 23V to .5 volt when I engaged the S1 to start/run jumped the CR1 diode still nothing, no crank, no power, no panel lights, etc etc, nothing

Yes, it's in normal

Yeah? I don't really see how that affects the power state of the generator, because now I don't get any working functions, no panel lights, clicking relays, solenoids or anything, the dead crank does still work but that is basically it, it's like the E-stop is engaged when in actuality it isn't

It looks good from what I can see, no pins pushed in, burnt or damaged etc etc

Hows this?

Got it, it was really on there, checked continuity, it was good from S10 terminal 3 to pin 14 J7 pin 14 to s17 terminal 1, don't know which one terminal 1 is, but both terminals had continuity, bottom terminal had a bit more resistance but not a large amount maybe 2-5 ohms?

How do you disconnect these connectors? Does it use some kind of twisting lock ring?

S10 terminal 3: 23V in off position .5V in start/run position I found connector J7, but I can't find P7, where is that located? nevermind found it, it's underneath

Got it will check now, thank you again.

Good morning so this is what I"ve found after going through all the checks S17 both terminals: .5 volt (prime & run) & start 23V in off CB1 both terminals: .5 volt (prime & run) & start 23V in...

That's good to know thank you, and yes I've checked the stop switch several times

I did before I switched the diodes, now I'm not sure but I'll check tomorrow morning.