002a/003a flywheel bolt pattern

[metalworker393]

Hello and how are you all doing. Do any of you have the bolt pattern on the flywheel that the 1/4-20 bolts go through for the flexplate ?
I can't find any drawing on the web for this flywheel. I looked for Delco patterns but could find nothing. Is there any drawing on this that the military has? I did not see any drawing in any of the TMs either.
Perhaps the bases where the machines are reset and rebuilt would have a drawing . If anybody has one can you send me a copy or post a drawing ?
Thanks, metalworker393

 

[Ray70]

Don't know of a document for what you need, but I do have a flywheel on the shelf. Worst case I could measure it for you and give you the dimensions.

 

[metalworker393]

Thanks Ray, might buy a spare if I can find 1.

 

[Guyfang]

The CECOM LAR's would have had that back in the day. But these sets have been gone too long. I will ask an old retired guy if he kept it. But dont think any of them have kept such things so long.

 

[metalworker393]

Okay, I measured a spare flex disc that had out in the garage. This is a scale measurement, but it looks dead on if you turn the disc so the flat is on a 45° angle

 

[metalworker393]

I'll buy a 1/4" thick plate and drill it out on the milling machine to verify the coordinates next.