Abnranger2
New member
- 1
- 0
- 0
- Location
- Mays landing, nj
Hello,
I recently replaced the rear brake light switch. After that was done, I lost brakes. Had brakes before replacing switch. I have tried manually bleeding them. The pedal goes straight to the floor.
About a year ago, I replaced the master cylinder and power boosted. I manually bled the system and that worked fine.
Could a bad brake light switch cause air to get into the lines? Not sure what else to do?
Any suggestions would be great! Thanks
I recently replaced the rear brake light switch. After that was done, I lost brakes. Had brakes before replacing switch. I have tried manually bleeding them. The pedal goes straight to the floor.
About a year ago, I replaced the master cylinder and power boosted. I manually bled the system and that worked fine.
Could a bad brake light switch cause air to get into the lines? Not sure what else to do?
Any suggestions would be great! Thanks
Last edited: