802-803 fuel pump

[69birdman]

Has anyone replaced the Faccett primary pump with the E8135 yet? It looks like a very tight stretch to get the inlet hose to reach ?

 

[Light in the Dark]

Are you replacing the cube style or the newer cylinder style?

 

[69birdman]

Are you replacing the cube style or the newer cylinder style?

The Cube Faccett, reuse the 90 & 45 on E8135. I've done a Cube to E1074 replacement, but not the E8135. Thought someone recently did but can't find the thread.

 

[Ray70]

I have used the E8135 to replace the round E1074 and like you said, it's a tight stretch.
I believe I ended up flipping the inlet and outlet upside down and using a couple other angle fittings to make it happen.
It definitely is not a drop in, but can easily be engineered with a few extra fittings.
The square pump to E8135 is a simple drop-in by reusing the fittings off the old square pump.
Cheap fittings are available from Discounthydraulichose.com , you would need to decide how you want to configure it and order a few extra options incase things don't fit as planned.

 

[69birdman]

I have used the E8135 to replace the round E1074 and like you said, it's a tight stretch.
I believe I ended up flipping the inlet and outlet upside down and using a couple other angle fittings to make it happen.
It definitely is not a drop in, but can easily be engineered with a few extra fittings.
The square pump to E8135 is a simple drop-in by reusing the fittings off the old square pump.
Cheap fittings are available from Discounthydraulichose.com , you would need to decide how you want to configure it and order a few extra options incase things don't fit as planned.

The square pump fittings do swap, but the overall length now (90-pump-45) is increased by 1-5/8" , the hard line can connect but now the input line is a tight stretch to reconnect.