Hiblade
New member
- 10
- 7
- 3
- Location
- CastleRock Washington
does anyone know where i can get curciut interupter switch for mep 803A generator.. number on old switch is 8906K4519 also on switch Mexico 0638 my email is blademan69 @msn.com
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
AC Curciut interupter switch
- Thread starter Hiblade
- Start date
- 3,823
- 5,922
- 113
- Location
- MA
Is your switch missing, or are you having troubles with a machine sending power to the lugs?
Hiblade
New member
- 10
- 7
- 3
- Location
- CastleRock Washington
switch is in place and it works most of the time. once in a while it wont let the power kick on. i would like to by a new one in case it quits working
- 3,823
- 5,922
- 113
- Location
- MA
I've never experienced a bad switch in that location, in these machines. Not to say its not possible, but your time and money is better served by taking the roof off an deoxidizing/cleaning/disassembling the K1 AC Circuit Interrupter. That is where your problem is most likely to lie.
Hiblade
New member
- 10
- 7
- 3
- Location
- CastleRock Washington
thanx i will try that if i can find it under there
- 3,823
- 5,922
- 113
- Location
- MA
Its the black box with the (3) yellow leads coming into/out of it, at lower edge of the photo.
Hiblade
New member
- 10
- 7
- 3
- Location
- CastleRock Washington
thanx a lot. that helps.. i will do it. i wish you lived close. i would hire you to kinda check the whole machine out. it does run good tho
- 3,823
- 5,922
- 113
- Location
- MA
Steel Soldiers is the bridge that connects us all. I'm just some monkey that has managed to retain more about these sets than I have forgotten... thats nothing special
- 16,722
- 23,982
- 113
- Location
- Burgkunstadt, Germany
Like LID, I have never seen this switch go bad. Its about bomb proof. Take your time removing the CB, and take it apart. Its not rocket Science. Simple, really. Clean it up, blow it out. Reassemble it. DO, REPEAT DO, remove the Neg. Battery terminal on the left side. Control panel is always the back side, so when you stand behind, even I can find left.
- 235
- 59
- 28
- Location
- glasgow,ky
The first 802a I ever owned had an intermittent AC interruptor switch. Metered OK when unit was not running, but would fail once it got started (vibrating). That's a weird switch... I always think of it as two switches in one housing. What gave it away was that the indicator light would go on and then shut off. Turned the switch back on and in a few seconds light would go off again. New switch, worked well and that gen is sitting on dolly at the barn.