Gamagoat1
Active member
- 746
- 44
- 28
- Location
- Kiowa, Colorado
Where can I get the valves that are on the 2 1/2 and 5 ton emergency and service air systems? I've got a couple leaking and need to replace them.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Air valves
- Thread starter Gamagoat1
- Start date
goldneagle
Well-known member
- 4,510
- 1,007
- 113
- Location
- Slidell, LA
Gamagoat1
Active member
- 746
- 44
- 28
- Location
- Kiowa, Colorado
Thanks
clinto
Moderator, wonderful human being & practicing Deuc
Staff member
Administrator
Super Moderator
Steel Soldiers Supporter
Supporting Vendor
- 12,596
- 1,132
- 113
- Location
- Athens, Ga.
Referring to the valve that's right in front of the gladhand? Where the hard line comes out of the frame rail?
Gamagoat1
Active member
- 746
- 44
- 28
- Location
- Kiowa, Colorado
Yes sir, that's the one.
clinto
Moderator, wonderful human being & practicing Deuc
Staff member
Administrator
Super Moderator
Steel Soldiers Supporter
Supporting Vendor
- 12,596
- 1,132
- 113
- Location
- Athens, Ga.
I haved looked around for replacements, one of mine has a mild leak. I have not had any luck sourcing a correct replacement. I have been told that I can disassemble and clean/rehab them.
Gamagoat1
Active member
- 746
- 44
- 28
- Location
- Kiowa, Colorado
They are both too far gone for rehab. looks like they were closed with a welding rod stuck in them.
Thanks for the answer!!!!!!!!
Thanks for the answer!!!!!!!!
- 2,102
- 30
- 38
- Location
- Delta Junction, Alaska
There are comercial ones availiable. They differ some in abberanve though. Otherwise, they are usually around on old vehicles, etc. I have noticed, they dont have a real high depamd, unless you need one.
Lee in Alaska
Lee in Alaska
Gamagoat1
Active member
- 746
- 44
- 28
- Location
- Kiowa, Colorado
Very true, Thanks Lee.
devilman96
New member
- 2,056
- 17
- 0
- Location
- Boca Raton, FL
I used 1/2 SS ball valves on mine but any 1/2 ball will work. Using a 3 way on the E side makes for a nice quick coupler connection.
Gamagoat1
Active member
- 746
- 44
- 28
- Location
- Kiowa, Colorado
That would make for a smooth operation. Thank you!
cbvet
Active member
- 1,567
- 20
- 38
- Location
- Northwest (Knox) Indiana
They look like common brass valves as used on natural & LP gas systems in homes.
I'll bet if you took one off & took it to a REAL hardware store, they could match it up.
If it were me, I'd just use current type ball valves.
Eric
CBVET
I'll bet if you took one off & took it to a REAL hardware store, they could match it up.
If it were me, I'd just use current type ball valves.
Eric
CBVET