- 12,195
- 319
- 0
- Location
- gainesville, ga.
use a gas ax on the nuts, then a BFH and a punch bar for the frame mount and unbolt and remove the axle mounts, place on some blocks, then the BFH
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
I thought so. I was thinking that one could make a whole new torque rod using some 3" ballistic fab joints and some DOM. the only problem would be that I believe the largest I have seen would accommodate a 3/4" bolt.
We get it, advertisements are annoying!
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!