• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Any suggestions for pre filter for external fuel pump

oddshot

Active member
781
119
43
Location
Jasper, Georgia
I am finally getting to the fuel projects I have planned for my truck. Driver side tank, upgraded spin-on fuel filters and external fuel pumps.

I'm planning on removing the in-tank pump & screen and replace it with a steel pickup tube.

I would like to plumb in some sort of garbage filter before the external pump.

Does anybody have any suggestions what I might use? Maybe something see through ... but it must be accessible and easily replaced. I have an M-105 bed on the truck, so clearance between the bed and tank is fairly limited.

BTW ... I found a couple cheap sources for these airtex fuel pumps:


This place has them for 30.00 plus shipping: FORGET THESE GUYS. PUT OF STOCK.

http://autoplicity.com/products/3505099-airtex_automotive_division_e8135_electric_fuel_pump.aspx


Northern auto has them for $40.00 plus shipping:


http://www.northernautoparts.com/part/a3-e8135


Thread on Steel soldiers about pump:


http://www.steelsoldiers.com/showthread.php?61149-24v-inline-fuel-pump/page4


There is some difference between the E8135 (gas) and the E8131 (diesel), but i don't see that it makes a whole lot of difference which on you choose.
 
Last edited:

JasonS

Well-known member
1,650
144
63
Location
Eastern SD
A buddy of mine builds generators using the multifuel and found that these cheap external pumps do not have enough flow. Why not just get one of the $50 units off of ebay and leave it as is? Seems like a lot less work.
 

red

Active member
1,988
25
38
Location
Eagle Mountain/Utah
I run CAT advanced filters on my 05 duramax, cost a little extra but they do a great job filtering the system. Will be installing the same spin on filter setup with the m35a2. The filter and mount that I use are a 1"x12 thread pitch. Able to get the mount for about 40-50 bucks.

If you're not worried about running a water separator in the pre-filter it will save you money. The setup on my 05 currently doesn't have a quality water separator (just the stock unit), but I'm a little picky about the fuel quality that goes in it. The m35a2 will get it because I plan to take mine on travels to remote areas, fuel quality will be more of a concern.
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks