Btharbold
New member
- 21
- 13
- 3
- Location
- Port Deposit, Md
Hello,
Recently purchased a 1045a2 and have been going over everything on the truck maintenance wise. Getting ready to do the blue hummer hub nut kits and since I will have the hubs open I figure might as well do input and output seals. I have seen some wet around the input seals on a couple and I’m sure with regular driving others won’t be far behind.
So far I have bought parts from several of the larger vendors.
Question is which vendor/manufacturer would have the best seals for this? Not sure who made the OEM seals, maybe CR. Would like to get the best parts I can.
Another question is on the shaft input seals, better to use the two seal setup or ditch the seal on the cv and use the single seal option in the retainer?
Thanks guys!
Recently purchased a 1045a2 and have been going over everything on the truck maintenance wise. Getting ready to do the blue hummer hub nut kits and since I will have the hubs open I figure might as well do input and output seals. I have seen some wet around the input seals on a couple and I’m sure with regular driving others won’t be far behind.
So far I have bought parts from several of the larger vendors.
Question is which vendor/manufacturer would have the best seals for this? Not sure who made the OEM seals, maybe CR. Would like to get the best parts I can.
Another question is on the shaft input seals, better to use the two seal setup or ditch the seal on the cv and use the single seal option in the retainer?
Thanks guys!