ianfotheringham
New member
- 13
- 0
- 0
- Location
- Toronto
Hey there team.
I'm busy tearing down a 52 m37, some previous owner decided he wanted a winch and stuck on an LU2 it would seem...not the factory LU4....anyway - i need to get it off before i sand blast - i thought the yoke might slide back enough to get it off the worm gear shaft going into the winch, but it isn't looking likely - thinking i have to remove the u-joint in place (?) - I'm not seeing any snap rings, wondering if anyone has any thoughts - heat? vice press it out in place? there's got to be an 'easier' way......
I'm busy tearing down a 52 m37, some previous owner decided he wanted a winch and stuck on an LU2 it would seem...not the factory LU4....anyway - i need to get it off before i sand blast - i thought the yoke might slide back enough to get it off the worm gear shaft going into the winch, but it isn't looking likely - thinking i have to remove the u-joint in place (?) - I'm not seeing any snap rings, wondering if anyone has any thoughts - heat? vice press it out in place? there's got to be an 'easier' way......
Attachments
-
35.8 KB Views: 24
-
42.6 KB Views: 21