Cab floor mats

[welldigger]

I'm new so please forgive me if I goof. I'm search for a duece, and after reading here I have a question. Couldn't you use a roll on bedliner like LineX? Or rhino lining? Thanks.

Yes same thing as spray on bed liner. Just applied differently.

 

[Repo3004]

Every truck I've owned I've had a spray in bed liner. My choice has been Linex for my last 3 trucks. Now that I've caught the MV bug, I don't want to pay someone else to do what I could do. After a LOT of reading other forums and watching hours of YouTube videos. I'm switching to Raptor Liner from U-Pol, everything comes in the kit (except for a compressor) and of course masking and cleaning supplies. They also have a liner that can be tinted to match existing colors. I can't swear by the product as I haven't sprayed mine in yet. My plan is to spray my bumpers and basically everything inside the cab, under the hood and chasis, and below the doors (gas tank-tool box etc...) as soon as it warms back up.

http://www.u-pol.com/product-cat/83/.htm

 

[Kloakndagr]

Well I just sprayed the entire cab with u-pol raptor tintable bed liner, very nice. I got the tint from Napa, I'm happy with the finished product.

 

[Merc1973]

Well I just sprayed the entire cab with u-pol raptor tintable bed liner, very nice. I got the tint from Napa, I'm happy with the finished product.

You know the rule... Pictures please.

 

[Kloakndagr]

You know the rule... Pictures please.

If I only could figure out how to do it from an iPad I would.

 

[Texascarnivor]

I built a highl-rack out of an old isuzu trooper and sprayed the whole thing with that stuff. It turned out well. It is not a rubbery finish like line-x. It's got texture and I think it sluffs of water better. I drive this thing through brambles and mesquites and after a year it's held up well. I used one kit for the whole thing

 

[M35A2-AZ]

I used the U-Pol liner in my two deuces also. I got the tint-able one and had some made to match the color of the trucks.

 

[glcaines]

I used the U-Pol liner in my two deuces also. I got the tint-able one and had some made to match the color of the trucks.

Looks very good!

 

[M35A2-AZ]

Thank you!!!

 

[shannondeese]

I used Mil-Spec walk way compound, Non-Skid. It works pretty good. It sealed every small hole and stopped some of the heat. Not enough in my opinion but it did make a difference.

 

[schnackj]

This is what I would like to put in my cab

http://www.mcmaster.com/#floor-mats/=pgpr15

has anyone made a good floor template they can share?

 

[Bobcat701]

Blueduce,

Thanks for the information. I am going to do that to my LMTV roof. I am also thinking about using a bed liner paint to do the floors.

 

[TsgtB]

After the floor is coated, do you do anything so you will be able to take the tunnel panels off later...?

 

[M35A2-AZ]

After the floor is coated, do you do anything so you will be able to take the tunnel panels off later...?

Yes you still can get the tunnel panels off.

 

[59apache]

I've done the same...
http://www.steelsoldiers.com/showthread.php?108993-paint-job&p=1381004&viewfull=1#post1381004
http://www.steelsoldiers.com/showthread.php?108993-paint-job&p=1380442&viewfull=1#post1380442

works good, makes a big difference!

 

[Paycheck]

I'm looking into rino lining the interior front to rear easy clean up and great insulation did with my jeep world of difference


Sent from my iPhone using Tapatalk

 

[Maverick1701]

I have two truck mats. I had to do some trimming. Ill snap a pic later this week.

 

[Hammer]

Almost 8 years later and I am still running the heavy stall mats as floor mats.
I had, and still have good paint under them.
I wouldn't put them down over any surface rust or bad paint though.

 

[13B40]

Why not keep it original and do what we did in Vietnam. A good thick layer of sand bags cuts down on the noise and small bits of shrapnel.

Ken

 

[59apache]

Because i'm not 18-20 years old and shrapnel is rare in southern bavaria these days