corelokt
Member
- 859
- 2
- 16
- Location
- Duffield, VA. (East of nowhere).
I'd like to have a CAI coming in from the side, maybe a stack type filter too. But I'm on a very tight budget now. My cone filter makes it challenging. Any ideas?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Cold air intake ideas? HX40 turbo.
- Thread starter corelokt
- Start date
Barrman
Well-known member
- 5,266
- 1,782
- 113
- Location
- Giddings, Texas
It has to be from the side? GM has cutouts in the front valence for a cold air intake already. Actually they are there on both sides of the radiator.
Sticking with your cone filter, you could build a box around it with the opening at the valence. GM and Banks both had air intake "caps" that fit into the cut outs. Basically, flat steel top with open sides to keep direct snow/rain/gunk from coming in. Ford trucks of all sizes have run circle filters inside of a housing for the last 15 years or so. I am sure a junk yard housing can be had cheap and made to fit your filter pretty easily.
That help?
Sticking with your cone filter, you could build a box around it with the opening at the valence. GM and Banks both had air intake "caps" that fit into the cut outs. Basically, flat steel top with open sides to keep direct snow/rain/gunk from coming in. Ford trucks of all sizes have run circle filters inside of a housing for the last 15 years or so. I am sure a junk yard housing can be had cheap and made to fit your filter pretty easily.
That help?
corelokt
Member
- 859
- 2
- 16
- Location
- Duffield, VA. (East of nowhere).
I have been avoiding using the front as I hope to have a charged air cooler some day.
- 3,342
- 1,329
- 113
- Location
- The actual midwest, NM.
As I recall, those factory inlets are way outside the radiator area, so there shouldn't be any interference unless you mount the charge air cooler partially in an air dead zone.
Barrman
Well-known member
- 5,266
- 1,782
- 113
- Location
- Giddings, Texas
I have a Banks intake cap on my M1007 project. It is between the passenger headlight and the Slave port mount.
- 2,479
- 25
- 38
- Location
- Houston Texas
I used all factory parts. The intake manifold and air filter are from a 93 6.2. The intake hose is from a 80's 350 small block. No more drone noise from the engine at speed. You can carry a conversation at 55MPH now. I got the parts from a junk yard. I have about $50 into it.Attachments
corelokt
Member
- 859
- 2
- 16
- Location
- Duffield, VA. (East of nowhere).
Nope I went out and looked it over today as I plumbed in my fuel filter and did a bunch of wiring. I've filled that corner with the radiator over flow, a final fuel filter, a coolant bypass filter, and a transmission filter. I'll have to run it down low either up front or in front of the inner fender. I'm wondering if I should just put a scoop above the filter and a heat shield below it.
llong66
New member
- 453
- 2
- 0
- Location
- kokomo, In
Hi, as Ken said, all factory parts, I had an '85 Silvarado gasser with that setup, the metal "core" was knocked out, a plastic, twist lock inset put in and a hose to the factory air cleaner. I know with what you have, that may not work, but if you move things around or anyone else wondered, its that easy!
Greg
Greg